Modification notes
Test and adjustment values for gap dimensions
Number | Designation | Model | |||
BE60.00-P-1001-01Q | Gap dimension | Engine hood to fender | Dimension "A" | mm | 4.0 (1) |
Engine hood to headlamp | Dimension "B" | mm | 4.0 (1) | ||
Headlamp to fender | Dimension "C" | mm | 4.0 (1) | ||
Engine hood to bumper | Dimension "D" | mm | 6.0 (-1.5/+2) | ||
Headlamp to bumper | Dimension "E" | mm | 4.0 (1) | ||
Engine hood to A-pillar | Dimension "F" | mm | 4.0 (1) | ||
See picture | |||||
BE60.00-P-1002-01Q | Gap dimension | A-pillar cover to front door | Dimension "G" | mm | 6.5 (1) |
Front door to fender | Dimension "H" | mm | 4.0 (1) | ||
Front door to rear door, bottom | Dimension "I" | mm | 4.0 (1) | ||
Front door to rear door, top | Dimension "J" | mm | 4.0 (1) | ||
Front door to A-pillar | Dimension "K" | mm | 6.5 (-0.5/+1) | ||
See picture | |||||
BE60.00-P-1003-01Q | Gap dimension | Rear door to side roof paneling | Dimension "L" | mm | 6.5 (-0.5/+1) |
Rear door to rear fender | Dimension "M" | mm | 4.0 (1) | ||
Rear door to rear side window | Dimension "N" | mm | 6.5 (1) | ||
Rear fender taillamp | Dimension "O" | mm | 2.5 (1) | ||
Rear fender to rear-end door | Dimension "P" | mm | 4.0 (1) | ||
See picture | |||||
BE60.00-P-1004-01Q | Gap dimension | Fuel filler flap | Dimension "Q" | mm | 4.0 (0.5) |
See picture | |||||
BE60.00-P-1005-01Q | Gap dimension | Bumper to taillamp | Dimension "R" | mm | 2.5 (1) |
Rear-end door to taillamp | Dimension "S" | mm | 3.5 (+1) | ||
Rear-end door to bumper | Dimension "T" | mm | 5.0 (2) | ||
Rear-end door to roof | Dimension "U" | mm | 4.5 (1) | ||
Taillamp in tailgate and taillamp | Dimension "V" | mm | 4.0 (1.5) | ||
See picture | |||||
Feeler gauge
129 589 03 21 00
P60.00-2666-06
Adjust hoods, doors and lids as shown in drawing. The gap should not run wedge-shaped or be too narrow at points. Deviations from parallel gap should be max. 0.5 mm over the entire length. If the inside clearance is too large or too small, the movable body parts must be centered accordingly. The reference measurements apply only for repair work on bodies damaged in accidents.
P60.00-2669-09