Shown on LHD vehicle |
1 | Adjustment screw (for right hydraulic steering limiter on left-hand drive vehicles; for left hydraulic steering limiter on right-hand drive vehicles) |
2 | Adjustment screw (for left hydraulic steering limiter on left-hand drive vehicles; for right hydraulic steering limiter on right-hand drive vehicles) |
W46.20-1064-01
W46.20-1063-01
Shown on steering gear for right-hand drive vehicles |
5 | Sliding bush |
W46.25-1027-11
Warning | Risk of injury caused by body parts being pinched or crushed as cab is tilted | Ensure that no one is within the tilting range of the cab as it is being tilted. Always tilt the cab all the way to the end position and secure it with the safety strut. | |
Warning | Risk of injury to skin or eyes from hydraulic fluid spraying out under pressure.Risk of poisoning from swallowing hydraulic fluid. | Depressurize hydraulic system completely before starting any work on it. Wear protective clothing and safety glasses. | |
Warning | Risk of injury from being trapped in the swivel range of steered axles | Ensure that no persons or objects are in the swivel range of all steered axles when turning the steering wheel. Do not stand in the swivel range of the additional steering axle when the engine is running. | |
Topical note | Notes on tilting the cab | ||
Topical note | Notes on maintenance and repair work | ||
| Remove | ||
1 | Move front wheels to straight-ahead position. | ||
2 | Open maintenance flap. | ||
3 | Tilt cab. | ||
4 | Remove noise encapsulation under steering gear. | ||
5 | Remove boot from steering gear. | ||
6 | Remove setting screws (1, 2). | Collect escaping oil in suitable container. | |
| Install | ||
7 | Install new setting screws (1, 2). | Adjustment bolt of automatically-adjusting hydraulic steering limiter in steering gear | |
8 | Attach boot to steering gear. | ||
9 | Install noise encapsulation under steering gear. | ||
10 | Fill and bleed steering gear oil. | ||
Turning the steering wheel to both the left and right end stop, causes the sliding bushings (5) on the adjustment screws (1, 2) to be automatically moved to the switch-off position. During the adjustment procedure, increased force must be applied to the steering wheel when turning the steering both mechanically and with hydraulic assistance. |