AR35.30-D-4815-04A | Install differential in rear axle housing | Rear axle 741.130/131/40/43/ 52/530/540/55 | |
Determining thickness of shims for differential on rear axle housing |
Test and adjustment values for rear axle drive
Number | Designation | Rear axle 741.40/43 | Rear axle 741.130/131 | Rear axle 741.52/53/ 54/55 | ||
BE35.30-N-1005-01B | Gear backlash of rear axle drive | mm | 0.10...0.15 | 0.10...0.15 | 0.10...0.15 | |
Rear axle drive
Number | Designation | Rear axle | Rear axle | |||
BA35.30-N-1002-02A | Bearing bracket, differential housing to axle center assembly | M10 | Stage 1 | Nm | 70 | 70 |
Stage 2 | ° | - | - | |||
M121.5 | Stage 1 | Nm | - | - | ||
Stage 2 | ° | - | - | |||
M162 | Nm | - | - | |||
Rear axle drive
Number | Designation | Rear axle | |||
BA35.30-N-1002-02A | Bearing bracket, differential housing to axle center assembly | M10 | Stage 1 | Nm | 70 |
Stage 2 | ° | - | |||
M121.5 | Stage 1 | Nm | - | ||
Stage 2 | ° | - | |||
M162 | Nm | - | |||
460 589 05 31 00
Spreader
001 589 53 21 00
Dial indicator
363 589 02 21 00
Dial indicator holder
D35.30-0065-01
D35.30-0064-01
1 Mount device (01, ) onto rear axle housing and tighten.
2 Insert the differential with the appropriately calculated shims into the rear axle housing.
Install the thinner shim on the ring gear side (arrow) so that the gear backlash is achieved in each case.
D35.30-0066-01
3 Release and remove device (01).
4 Insert bearing bracket (16) and tighten bolts by hand.
Observe markings on bearing bracket.
D35.30-0067-01
5 Check gear backlash (01, 02, )
The gear backlash can be altered by installing shims.
If a thinner shim is installed on one side, a shim which is thicker by the same amount must be installed on the opposite side so that the preload of the axle housing bearing is retained.
6 Compare measured play with the specified value, if necessary install different shims.
D35.30-0068-01
7 Tighten retaining bolts for bearing bracket .