ar3320p050002a

Check/adjust installation position of upper transverse control arm relative to bearing shell

Vrsta ar · tema 33.20 · različica 0106 · 2010-01-21

Velja za: MODEL 140.### #A as of 184315

Ni na voljo v jeziku »sl«; prikazano v jeziku Angleščina.

Umestitev

Funkcijska skupina 2 Podvozje › 33 Sprednja prema › 33.20 Obese koles, pesto — Serija 140

EinPAS 17 pogonski sklop/prema › 17.50 sprednja prema › 17.50.41 prečno vodilo/vodilo/stabilizator — Serija 140

AR33.20-P-0500-02A

Check/adjust installation position of upper transverse control arm relative to bearing shell

Test specifications for wheel location, wheel hub

Number

Designation

Model
140

BE33.20-P-1001-01A

Test dimension "A" for adjusting the upper wishbone in the bearing shell

mm

63

See picture

AR33.20-P-0500-02A

Wheel location, hub

Number

Designation

Model
140

BA33.20-P-1008-01A

Self-locking nut of upper wishbone in bearing shell

Nm

120

Check/adjust installation position of upper transverse control arm relative to bearing shell

P33.20-0285-02

The bearing shell (6a) is screwed on to the upper transverse control arm (6) in a defined position (dimension A see Table. In the event of deviation, adjust the incline angle of the upper transverse control arm.

1 Loosen self-locking nut (6e).

2 Adjust incline angle of upper transverse control arm as per check dimension "A".

3 Tighten self-locking nut (6e) with specified .