P64.20-5354-05
1 Expose spot welds on rear center section and cut out (areas A, B, C and D).
P64.20-5234-06
2 Expose spot welds on rear center section and cut out (areas G, G1, H and H1).
Cut through two panel thicknesses (arrows).
P64.20-5247-06
3 Heat rear center section (1) in crosshatched areas.
Crosshatched areas are bonded.
4 Bend sheet metal lugs in connecting area of rear fender to rear center section (1) toward outside (arrows).
5 Remove damaged rear center section (1).
P64.20-5355-09
6 Grind down connection surfaces on body to bare metal in crosshatched areas.
Sand spot weld flanges to bare metal on both sides
7 Remove drill shavings.
8 Coat insides of spot weld flanges with zinc dust paint.
Do not coat bonding surfaces with zinc dust paint to avoid adhesion problems (areas I, J, K, L, M and N).
Observe pretreatment of bonding surfaces.