P63.50-3726-09
1 Install rear fender, trunk lid, left rear lamp unit (E3) and rubber seal and fit.
2 Check and adjust gaps.
3 Fix rear fender in place.
4 Remove trunk lid, left rear lamp unit and rubber seals.
5 Drill Ø 6.7 mm on rear fender (area A and B).
6 Remove rear fender.
7 Deburr rivet holes on rear fender on both sides.
8 Coat insides of riveted joints with zinc dust paint.
P63.50-3727-06
9 Install rubber window spacers from glazing repair kit as spacers on outer rear wheel well at uniform intervals (area D).
10 Apply sealant to outer rear wheel well and foam parts (area C, D and E).
Always replace damaged foam parts which can no longer be used. New foam parts are available only from the responsible Daimler department.
11 Apply 2-component adhesive in crosshatched areas.
Refer to the manufacturer's information for the curing and working times of 2-component adhesive.
Observe pretreatment of bonding surfaces.
P63.50-3728-09
12 Install rear fender, fit and fix in place.
13 Rivet rear fender with Ø 6.414 Polygrip flat/round head rivets (area F).
14 Rear fender (areas G, H, J and K).
15 MIG solder rear fender (area I).
P63.50-3729-09
16 Rivet rear fender with Ø 6.414 Polygrip flat/round head rivet (area L).
17 Rear fender (areas M, N and O).
18 Rear fender (area P).