Measuring basic dimension on differential

Тип ar · тема 35.30 · версия 0104 · 2001-07-24

Применимость: REAR AXLE 741.130 /131 /404 /405 /408 /436 /438 /439 /52 /530 /540 /55 with CODE (A71) Rear axle with differential lock REAR AXLE 741.407 with CODE (A71) Rear axle with differential lock with CODE (AC7) Rear axle ratio i = 3.272 with CODE (AE1) Rear axle ratio i = 2.923 REAR AXLE 741.130 /408 in MODEL 690.6 with CODE (A71) Rear axle with differential lock

Нет на языке «ru»; показано на языке Английский.

Расположение

Функциональная группа 2 Ходовая часть › 35 Задний мост › 35.30 Привод, приводные валы — Серия 690 (модели 6**)

EinPAS 17 Трансмиссия / мост › 17.51 Задний мост › 17.51.65 Редуктор заднего моста / сквозной привод — Серия 690 (модели 6**)

Также относится к двигателям/коробкам передач: 741 130, 741 131, 741 404, 741 405, 741 407, 741 408, 741 436, 741 438, 741 439, 741 52*, 741 530, 741 540, 741 55*

AR35.30-D-4815-02B

Measuring basic dimension on differential

601 589 00 21 00

Adjustment device

460 589 03 63 00

Ring

D35.30-0072-01

A Measuring internal dimension of axle housing

1 Push spacer ring () onto left-hand side of measuring device (02, ).

2 Install measuring device (02, ) in rear axle housing and measure gap using feeler gauge (a).

2 Determine internal dimension of housing and note measurement.
 The internal dimension is calculated by adding the size of the special tool and the measurement for the gap.

Example: Special tool size 163.8 mm

Feeler gauge gap 1.1 mm

Internal housing dimension 164.9 mm

D35.30-0073-01

B Measuring differential

1 Place differential on a level surface with one 5mm thick shim at the top and another at the bottom, and meaasure the overall height (arrows).

Example: Differential measured with shims 164.1 mm

Differential without shims 154.1 mm