T83.25-0003-01
Dust filter | ||||
3 | Dust filter | |||
4 | Heater housing | |||
Routing of wiring harnesses | ||||
4 | Heater housing | |||
6 | Electrical connector | |||
T83.25-0004-01
T83.25-0005-01
4 | Heater housing | |||
5 | Screw | |||
4 | Heater housing | |||
6 | Electrical connector | |||
7 | Refrigerant line | |||
T83.25-0009-01
| Remove/install | ||
Warning | Risk of injury to skin and eyes suffering scalding from contact with hot coolantspray. Risk of poisoning from swallowing coolant. | Do not open cooling system unless coolant temperature is below 90 °C. Open cap slowly and release the pressure. Do not pour coolant into beverage containers. | |
Danger | Risk of explosion caused by welding or soldering work on closed air conditioning system. Risk of poisoning caused by inhaling overheated refrigerant vapors. Risk of injury to skin and eyes caused by contact with liquid refrigerant. | Never perform welding work on or near a closed air conditioning system. No smoking or open flames. Wear safety glasses and protective gloves. Work only in well ventilated areas. Carry out repair work on the air conditioning system circuit only after the system has been drained. | |
Topical note | Protect air conditioning circuit and components from moisture when carrying out repair work | ||
Topical note | Procedure for a damaged or leaky air conditioning system | ||
Topical note | Notes on coolant | ||
Notes on handling refrigerant R134a | |||
1 | Drain air conditioning system | Discharge air conditioning system | |
Discharge air conditioning systemModel NMB613.455 | |||
2 | Remove spare tire | See owner's manual. | |
3 | Depressurize compressed-air circuit for auxiliary consumers | ||
4 | Close shutoff valves for heating feed line and return line | See owner's manual. | |
5 | Remove dust filter (3) of heater box (4) | ||
| |||
Installation: Check dust filter (3); replace if necessary. | |||
6 | Remove electrical wiring harnesses from electrical connectors (6) at heater box (4) | Installation: Ensure that electric wiring harness is routed properly. | |
7 | Disconnect compressed-air line to heater box (4) at connector coupling | ||
8 | Loosen hose clamps and detach heater hoses from heater box (4) | Clamp off heater hoses using locking pliers. Collect escaping coolant. | |
Installation: Check coolant hoses and replace if necessary. | |||
9 | Remove condensation drain hose from vehicle frame | Only with code HO4 (Front air conditioning system) (Konvekta air conditioner housing version) | |
10 | Disconnect refrigerant lines (7) of air conditioning system from heater box (4) | ||
| Compressor oils (specification 362.0) | ||
Installation: Do not swap refrigerant lines (7). | |||
11 | Remove screws (5) from heater box (4) at vehicle frame | ||
12 | Lift heater box (4) slightly and pull out toward front | Two elastomer bearings are attached to the rear panel of the heater box (4). These are inserted vertically in two guide bearing panels when the heater box (4) is in its installed state. | |
Installation: Check elastomer bearings; replace if necessary. For easier assembly, treat the side insulations of the heater box (4) with lubricant. | |||
13 | Install in the reverse order | ||
14 | Evacuate air conditioning system and perform leak test |
| |
Model NMB613.455 | |||
15 | Fill air conditioning system |
| |
Model NMB613.455 | |||
16 | Pour in coolant | ||
| Engine cooling system - check fluid level, adjust to correct level. Inspect anticorrosion/antifreeze protection, adjust to correct concentration | ||
Cooling system is bled automatically. | |||
17 | Carry out function check | ||
| Heater and ventilation, heater booster - function check | Model NMB613.355/358/388/455/485 without air conditioning | |
| Air conditioning system - function check | Model 613.355/358/388/455/485 | |
| Air conditioning system - function check | Model NMB613.455 | |
| Air conditioning system - function check | Model NMB613.358/388 | |
| Air conditioning system - function check | Model NMB613.455 |
Documente menționate
- ah2000n208001a Indicaţii pentru lichid de răcire
- ah8330n000301a Indicaţii pentru manipularea refrigerentului R134a
- ah8330n000401a Comportament dacă instalaţia de climatizare este avariată respectiv neetanşă
- ah8330n000501a Protejarea circuitului şi componentelor instalaţiei de climatizare împotriva umidităţii la lucrările de reparaţie
- ap2000t2010a Verificaţi nivelul de lichid al sistemul de răcire motor, reglaţi. Verificarea, completarea anticorozivului/antigelului
- ap8300t8351b
- ap8300t8352ba
- ap8300t8352bac
- ap8300t8352bad
- ap8300t8352baf
- ap8300t8352bas
- ap8300t8381ba
- ap8300t8381baf
- ap8300t8381bas
- ap8300t8381bat
- ar8330t1762bas
- ar8330t1762bas
- ar8330t1762c
- ar8330t1777bas
- ar8330t1777bas
- ar8330t1777c
- ar8330t1777c
- ar8330t1780bas
- ar8330t1780bas
- ar8330t1780c
- as2000z000101a Pericol de rănire la piele şi ochi prin opărire cu lichid de răcire fierbinte pulverizat afară. Pericol de otrăvire datorită înghiţirii lichid de răcire.
- as8300z000101a Pericol de explozie datorită lucrărilor de lipire sau sudură la instalaţia de climatizare oprită. Pericol de otrăvire prin inhalarea de vapori de refrigerent supraîncălziţi. Pericol de rănire prin contactul pielii şi ochilor cu
- bb0040p036200a Uleiuri de compresor (specificaţie 362.0)