Remove and install wiper arm

AR82.30-P-6100RT

Remove and install wiper arm

3.2.11

11.1.11

BA table added

Steps 5, 6

*BA82.30-P-1003-01K

 

Remove/install

 Danger!

Risk of injury caused by moving parts that can pinch, crush or, in extreme cases even sever extremities.

Always remove ignition key when working on windshield wiper mechanism.

AS82.30-Z-0001-01A



Installation: Information on aligning wiper arms

See: 

Check wiper arms and adjust

AR82.30-P-6000RT

1

Move the wiper arms into park position and switch off the wiper system

2

Switch off ignition and remove the transmitter key from the EZS control unit

 On vehicles with code (889) Keyless Go: Press keyless go start/stop button repeatedly until ignition is switched off. Remove transmitter key from vehicle and store it in a location beyond its transmission range (at least 2 m).

3

Open engine hood and raise to vertical position

AR88.40-P-1000RT

4

Raise cover (3) on driver side wiper arm (2)

 When removing driver side wiper arm (2).

5

Unscrew nut (4) and loosen driver side wiper arm (2) drive shaft and remove

 When removing driver side wiper arm (2).

 Carefully remove driver side wiper arm (2) to prevent damaging paint on engine hood.

 The wiper arm should not spring back on the windshield to prevent damage.



*BA82.30-P-1003-01K

6

Unscrew nut (5) on passenger side wiper arm (1)

 When removing passenger side wiper arm (1).



*BA82.30-P-1003-01K

7

Loosen passenger side wiper arm (1) from wiper drive shaft and remove

 When removing passenger side wiper arm (1).

 Carefully remove passenger side wiper arm (1) to prevent damaging paint on engine hood.

 The wiper arm should not spring back on the windshield to prevent damage.

8

Install in the reverse order

9

Check wiper arms and adjust

AR82.30-P-6000RT

10

Carry out function check

AP82.30-P-8252RT

Number

Designation

Model 251

BA82.30-P-1003-01K

Nut on wiper motor shaft

Nm

32