ar8210p4730so

Remove/install headlamp unit

Tip ar · temă 82.10 · versiune 0100 · 2003-12-04

Valabil pentru: MODEL 450.3 /4 as of 11.2.02

Nu este disponibil în „ro”; afișat în Engleză.

Încadrare

Grupă funcțională 3 Suprastructură › 82 Instalaţie electrică, structură › 82.10 Sistem de iluminat exterior — Seria 450 (modele 3**, 4**)

EinPAS 30 Instalaţie de iluminat › 30.15 Sistem de iluminare exterior › 30.15.40 Lumină față — Seria 450 (modele 3**, 4**)

AR82.10-P-4730SO

Remove/install headlamp unit

26.6.02

MODEL 450.3 /4 as of 11.2.02

Remove/install headlamp unit

P82.10-3246-06

1 Bolt

2 Bolt

3 Screws

4 Connector

E1 Left front headlamp unit

E2 Right front headlamp unit

Remove

Danger!

Risk of injury in the form of trapping or crushing, or even severing of limbs, if caught in windshield wiper mechanism

Always remove ignition key when working on windshield wiper mechanism.

AS82.30-Z-0001-01A

1

Remove CBS Front

AR88.00-P-1010SM

2.1

Remove service grill on the right

Not on vehicles with code (L15) United Kingdom, (L16) Japan.

3.1

Remove air inlet

Not on vehicles with code (L15) United Kingdom, (L16) Japan.

AR83.25-P-1401SM

4

Disconnect plug (4) from the lamp unit (E1, E2)

Pay attention to locking lugs.

5

Unscrew bolt (1)

6.1

Mark installation position of lamp unit (E1, E2)

Only if lamp unit (E1, E2) is not replaced.

7

Unscrew screws (2, 3)

8

Remove lamp unit (E1, E2)

Install

9

Insert and position lamp unit (E1, E2)

Align with marking if necessary.

10

Tighten screws (3)

If it is not possible to tighten the bolts (3), the fixing adapters on the carrier are to be removed/installed in accordance with the following information. Refer to:

Remove fixing adapter on headlamp.

AR82.10-P-4728-01SO

11

Tighten screw (2)

The washer of the bolt (2) and embossing (arrow) must coincide.

12

Insert CBS Front and check positioning

Pay attention to even distance of CBS Front to lamp unit.

CBS Front must not contact the lamp unit (E1, E2).

If adjustment is required, note the correction distances.

13

Remove CBS Front

Adjust lamp unit (E1, E2) if necessary.

14

Tighten bolt (1)

15

Connect plug (4) to the lamp unit (E1, E2)

Pay attention to the plug locking in position.

16

Adjust lamp unit (E1, E2)

Check and correct headlamp adjustment

AP82.10-P-8260SM

17

Install CBS Front

AR88.00-P-1010SM

18.1

Install air inlet

Not on vehicles with code (L15) United Kingdom, (L16) Japan.

AR83.25-P-1401SM

19.1

Install service grill on the right

Not on vehicles with code (L15) United Kingdom, (L16) Japan.

Documente menționate