P46.10-2627-06
1 Bolt (up to 2.3.08 or without code (809) Model year 2009)
2 Inner race
5 Carrier plate
a Catch hook
N49 Steering angle sensor
N80 Steering column module
| Remove/install | ||
| Steering angle sensor (N49) and steering column module (N80) form one component and can only be replaced together | ||
1 | Remove clock spring contact | ||
2.1 | Unscrew bolt (1) | On vehicles up to 2.3.08 or without code (809) Model year 2009 | |
2.2 | Lift steering angle sensor (N49) over the guide pin | On vehicles as of 3.3.08 or with code (809) Model year 2009 | |
Bolt (1) replaced by a guide pin. | |||
3 | Unclip catch hooks (a) of steering column module (N80) from carrier plate (5) | ||
4 | Pull out steering angle sensor (N49) from carrier plate (5) | Installation: Check basic position of steering angle sensor (N49) (observe arrows on steering angle sensor (N49) and inner race (2). If the steering angle sensor (N49) twists, move the steering angle sensor (N49) into the center position before installing it again: To do so, carefully turn the inner race (2) of the steering angle sensor (N49) in a counterclockwise direction all the way to the limit stop. Turn inner race (2) of steering angle sensor (N49) lightly up to the limit stop, as otherwise it may be damaged. Finally, turn the inner race (2) through approx. two rotations in a clockwise direction, until the arrows on the steering angle sensor (N49) and inner race (2) line up. | |
5 | Install in the reverse order |