Check and adjust camber and caster at front axle

AR40.20-P-0322E

Check and adjust camber and caster at front axle

25.9.96

10.9.03

Reference to adjusting toe-in at the front and rear axle replaced by reference to chassis alignment

Step 9



Check

1

Observe general information on chassis alignment

AR40.20-P-0201A

2

Check vehicle level at front and rear axles with electronic inclinometer

AR40.20-P-0301D

3

Check camber and assign tabular value

AR40.20-P-0322-02D

4

Check caster and assign tabular value

 Measurement with wheels turned 20°.

AR40.20-P-0322-03E

Adjust

5

Raise vehicle.

6

Install adjusting washers (19d)

 Screw on nut (19b) of repair kit until it abuts, but do not tighten yet, so that the rubber mount of the transverse control arm can twist when the vehicle is rocked to settle the suspension.

AR40.20-P-0322-04A

7

Check the vehicle level at the front axle again after the camber and caster adjustment

 The vehicle level must match the dimension established during the initial measurement.

AR40.20-P-0301D

8

Tighten nut (19b) of the repair kit

 Installation: The repair bolt (19c) should be counterhold when tightening the nut (19b) of the repair kit.

 Check the installation position of the adjusting washers (19d) again.



*BA40.20-P-1005-01A

9

Check toe-in at front and rear axle and adjust if necessary.

See 

Perform chassis alignment check

AR40.20-P-0200A

Number

Designation

Model 210

BA40.20-P-1005-01A

Nut, repair kit

Nm

110