ar3320p050002a

Check/adjust installation position of upper transverse control arm relative to bearing shell

Tip ar · temă 33.20 · versiune 0106 · 2010-01-21

Valabil pentru: MODEL 140.### #A as of 184315

Nu este disponibil în „ro”; afișat în Engleză.

Încadrare

Grupă funcțională 2 Sistem de rulare › 33 Punte faţă › 33.20 Sistem de ghidare a roţii, butuc — Seria 140

EinPAS 17 Grup motopropulsor/Punte › 17.50 Punte faţă › 17.50.41 Braț transversal/Braț/Bară stabilizatoare — Seria 140

AR33.20-P-0500-02A

Check/adjust installation position of upper transverse control arm relative to bearing shell

Test specifications for wheel location, wheel hub

Number

Designation

Model
140

BE33.20-P-1001-01A

Test dimension "A" for adjusting the upper wishbone in the bearing shell

mm

63

See picture

AR33.20-P-0500-02A

Wheel location, hub

Number

Designation

Model
140

BA33.20-P-1008-01A

Self-locking nut of upper wishbone in bearing shell

Nm

120

Check/adjust installation position of upper transverse control arm relative to bearing shell

P33.20-0285-02

The bearing shell (6a) is screwed on to the upper transverse control arm (6) in a defined position (dimension A see Table. In the event of deviation, adjust the incline angle of the upper transverse control arm.

1 Loosen self-locking nut (6e).

2 Adjust incline angle of upper transverse control arm as per check dimension "A".

3 Tighten self-locking nut (6e) with specified .