P72.20-2491-07
1 Door lining
3 Door handle recess for emergency unlocking
2 Load compartment lamp
P72.20-2492-06
1 Door lining
3 Door handle recess for emergency unlocking
4 Side window frame paneling
5 Upper window frame paneling
6 Handle strip door lining
| Remove/Install | ||
Danger! | Risk of injury caused by fingers being jammed or pinched when removing, installing or aligning hoods, doors, trunk lid/rear-end door or sliding roof. | When moving components, ensure that no body parts or limbs are within the operating range of moving parts. | |
Removal | Danger of breaking and tearing plastic paneling parts and associated clip retainer | ||
1 | Unclip upper window frame paneling (5) and remove | Move mounting wedge directly to mounting clips (arrows). | |
Mounting wedge | |||
2 | Unclip side window frame paneling (4) and remove | Move mounting wedge directly to mounting clips (arrows). | |
Mounting wedge | |||
3 | Unclip door handle recess for emergency unlocking (3) from door lining (1) | ||
4 | Unclip load compartment lamp (2) and disconnect electrical connector | ||
5 | Unclip handle strip door lining (6) and remove | Move mounting wedge directly to mounting clips (arrows). Installation:Pivot retaining lugs into door lining (1) and clip in handle strip door lining (6). | |
Mounting wedge | |||
6 | Unclip door lining (1) from paneling | Start unclipping at right and left Move mounting wedge directly to mounting clips (arrows). | |
Mounting wedge | |||
7 | Remove door lining (1) from center paneling | Installation: Replace mounting clips (arrows) | |
8 | Install in the reverse order |
Mounting wedge
110 589 03 59 00
Documentos referenciados
- as0000z001101a Risco de lesão ao esmagar ou prender os dedos ao remover, instalar e em trabalhos de regulagem nas capotas, portas, tampas e no teto corrediço