P72.12-2648-09
Shown on model 251.1
1 Door lining
2 Trim panel
3 Door module
4 Bolts
5 Connector
6 Locking clamp
7 Bolts
8 Mounting
9 Connector
P72.12-2653-09
Shown on model 251.1
3 Door module
10 Bolts
11 Bolts
12 Cable retainer
13 Retainer tab
14 Bolt
15 Bolt
16 Window guide rail
| Remove/Install | ||
1 | Remove door lining (1), paneling (2) from window frame and crank window | ||
| |||
2 | Remove outside door handle on rear door | ||
3 | Unscrew bolts (4) until door lock can be moved back and forth | ||
4 | Open driver or passenger door, unlock locking clamp (6) with suitable tool and open, disconnect connector (5) from door separation point | ||
5 | Unscrew bolts (7) and remove frame (8) | ||
6 | Loosen connector (9) on upper and lower retainer tabs and allow connector (9) to fall into door from inside | ||
7 | Remove bolts (10, 11) | ||
8 | Remove door module (3) from rear door until retainer tab (13) is accessible | ||
9 | Loosen retainer tab (13) and remove wiring (12) toward outside | ||
10 | Remove door module (3) | Remove bolts (4) by moving door module (3) toward front of vehicle. | |
11 | Unscrew bolts (14, 15) and loosen window guide rail (16) from triangular window | ||
12 | Pivot window guide rail (16) toward front with upper end (arrow A), then turn 90° around its center (arrow B) and remove downward from window slot | The window guide rail (16) should not hit against the inner door panel during removal, otherwise the paint on the door panel and/or the window guide rail (16) can be damaged. | |
13 | Install in the reverse order |
Rear door