46.15-010 Removing and installing valve
1 Screw cap | 40 to 50 Nm. |
2 Valve plug | |
3 O-ring | Replace. |
4 Spring | |
5 Valve with pressure limiter |
Removing
------------------------------
1 Unscrew screw cap (1).
2 Take off O-ring (3).
3 Remove valve plug (2) from screw cap (1).
4 Take out spring (4) and valve (5).
5 Check valve (5) for scoring, wear and jamming in the pump housing bore.
Note
If scoring is detected on the contact surface of the bore, the entire power steering pump assembly must be replaced. Never replace just the valve (5).
Installing
------------------------------
1 Immerse valve (5) and spring (4) in ATF and install.
2 Install valve plug (2) in screw cap (1).
Note
The slot in the valve plug (2) must point towards the spring.
3 Tighten screw cap (1) with new O-ring (3) to 40 to 50 Nm.
4 Check power steering pump (46.13-010).
Powiązane dokumenty
- bb0040p023603a Oleje do przekładni kierowniczych ATF (specyfikacja 236.3)
- bb0040p023606a Oleje do przekładni hydrokinetycznych ATF (specyfikacja 236.6)
- bb0040p023607a Oleje do przekładni hydrokinetycznych ATF (specyfikacja 236.7)
- ra4613lhp0010x
- ra4615lhp0003x
- ra4615lhp0005x