S82.61-4003-06
1 GPS antenna
A9 Radio and navigation control module
| Remove | ||
1 | Remove front seat | Driver seat | |
| |||
2 | Remove side access plate and upper cover from driver's seat frame | ||
3 | Disconnect ground cable of battery | Installation: Set the time in the instrument cluster and, with stationary heater, on the timer. | |
4 | Loosen wheelhouse cover on driver's side | ||
5.1 | Remove paneling below instrument panel in driver's footwell | Model 638.294 | |
6 | Remove door sill molding from driver's door | ||
7 | Remove paneling from A-pillar on driver's side | ||
8 | Loosen headliner in area between A-pillar on driver's side and rearview mirror above windshield | ||
9 | Remove instrument cluster | Loosen instrument cluster only, do not disconnect connector. | |
| Model 638.01/03/06/07/11/13/16/17/21/23/ 24/27 | ||
| Models 638.09/19/29 | ||
10.1 | Remove radio | ||
10.2 | Remove cover from radio installation shaft | Vehicles without radio | |
| Install | ||
11.1 | Install radio preequipment | Only if radio, radio antenna and loudspeakers are not present. | |
12 | Preparing vehicle electrical system for retrofitting navigation system | ||
13 | Retrofit GPS antenna | ||
14 | Fit remaining parts to vehicle | ||
15 | Connect radio connector, radio antenna and GPS antenna to radio and navigation control module and install control module. | ||
16 | Enter equipment code for radio and navigation control module according to operating instructions. | ||
17 | Load navigation CD and wait until connection to at least 3 satellites is completed. | ||
18 | Perform system settings according to operating instructions. | Enter language, time and tire size. | |
19 | Check for proper function and perform test drive. |
Parts ordering notes
Part no. | Designation | Quantity |
B6 656 01 81 | Sound 30 APS navigation unit | 1 |
B6 656 01 83 | Installation kit for Sound 30 APS | 1 |
A 002 546 74 40 | Cutting clamp for wire cross section of 0.35 to 0.75 mm2 | 1 |