P80.20-3692-09
1 Bracket
2 Bolts
3 Central locking (CL) element socket
4 Bolts
7.2 Black 3-pin plug
7.3 Black 3-pin coupling
X58/23 Charger feed-in socket
5 Black 3-pin coupling
6 Cable tie
7 Adapter line
7.1 Black 4-pin coupling
| Remove | ||
1 | Remove rear CBS | ||
2 | Unscrew bolts (2) and remove charger feed socket (X58/23) from bracket (1) | ||
| Install | ||
3 | Drill hole (arrow A) with Ø 5 mm drill bit | Only drill through approx. 2 cm thick outer water in charger feed socket (X58/23). Otherwise the shielding of the individual poles (arrow B) can be damaged and the charger feed socket (X58/23) must be replaced. | |
Rechargeable drill / screwdriver gotis://G_58.0_01.1 | |||
4 | Position CL element socket (3) above opening (arrow A) and tighten bolts (4) included in scope of supply | ||
5 | Connect black 3-pin coupling (5) to black 3-pin connector (7.2) of adapter line (7). | The black, 3-pin coupling (5) was connected previously to the fuel filler flap CL motor The adapter line (7) is not included in the scope of delivery. | |
6 | Connect black 4-pin coupling (7.1) to CL element socket (3) | ||
7 | Fasten connector on adapter line (7) to bracket (1) on charger feed socket (X58/23) with cable tie (6) as shown. | Route wiring harness on fuel filler flap CL motor below charger feed socket (X58/23). | |
8 | Position bracket (1) with charger feed socket (X58/23) and tighten with bolts (2) | ||
9 | Install CBS rear end | ||
10 | Check CL element socket (3) and CL fuel filler flap motor for proper function |