Remove/install rear CBS

AR88.20-P-1900MCC

Remove/install rear CBS

21.10.11

 

Remove/install

1

Remove left and right longitudinal member panel

AR88.80-P-6000MCC

2

Open liftgate

3

Remove covers (10) and disconnect electrical connector (11) from left taillamp (E3) and right taillamp (E4)

4

Unscrew bolts (1) from rear CBS (2).

 Previously unclip covers at the two lower bolts (1) in the rear apron.

5

Unscrew mounting bolt (9).

With code (E14) Basic carrier

6

Loosen catch hook (5) on left and right bottom on rear CBS (2).

7.1

Open fuel filler flap (4) and unscrew lock (7).

Not on model 451.391/491

7.2

Open charger feed-in socket flap (12)

On model 451.391/491

8

Carefully loosen rear CBS (2) in marked area (arrows) starting at bottom with assembly wedge.

 Assembly wedge

*110589035900

 Installation: Slide seal (6) over tank filler neck or charger feed-in socket (X58/23) and align.

9.1

Slightly pull rear CBS (2) toward outside in area of fuel filler flap (4) and disconnect electrical connector (8) from fuel filler flap CL motor (M14/10)

Not on model 451.391/491

9.2

Slightly pull CBS rear-end (2) toward outside in area of charger feed-in socket flap (12) and disconnect electrical connector (8) from charger feed-in socket motor (M14/11)

On model 451.391/491

10

Close rear-end door

11

Guide rear CBS (2) downward along rear-end door on left.

 Carefully remove rear CBS (2). Otherwise, the rear-end door and the rear CBS (2) can be scratched.

 Aid of helper required.

12

Guide rear CBS (2) downward along rear-end door on right side and remove.

 Carefully remove rear CBS (2). Otherwise, the rear-end door and the rear CBS (2) can be scratched.

 Lay rear CBS (2) down on suitable subsurface.

Helper required

13

Loosen latch (7) on fuel filler flap (4) and close tank filler neck

Not on model 451.391/491

14

Install in the reverse order

15

Check left taillamp (E3) and right taillamp (E4) for proper function