S97.20-4507-10
Engine hood area
S97.20-4503-09
Area of left and right front door
Sliding door area
S97.20-4506-08
Rear-end door area
Left and right rear hinged door area
Danger! | Risk of explosion and poisoning caused by solvent vapors and gasses. Risk of injury to skin and eyes when working with anticorrosion agents | Never spray anticorrosion agents on flames or glowing hot objects and keep them well away from all potential sources of ignition. Use them only in well-ventilated rooms; wear respiratory protection. | |
| Notes on cavity preservation | ||
1 | Perform repair preservation in crosshatched areas through vehicle openings (arrows). | Apply cavity sealant from inside in crosshatched areas following sealing and paintwork, however, before performing assembly work. Apply repair preservation agent twice with a drying time of 5 minutes in between. | |
The spraying hose should be stiff and the nozzles should spray at angle to the front and rear. The cavities should be dry. | |||
Insert spray hoses as far as possible into cavities. Spray while inserting and pulling out slowly. | |||
The processing temperature should not be less than 15 °C. Additional preservation measures may be required, depending on the repair area, deviating from the standard cavity preservation shown. | |||
| Processing instructions for cavity preservation agent | ||
| Cavity protection, general | ||
Combination pressure spray gun (corrosion protection) | |||
MB cavity wax preservation, 1 l | |||
2 | Remove cavity sealant from drain holes |
Repair materials
Number | Designation | Order number |
BR00.45-Z-1003-05A | Cavity sealant, solvent-free (1 l container) | A 000 986 72 70 05 |
Powiązane dokumenty
- ah9720p000101b Wskazówki dotyczące konserwacji profili zamkniętych
- ap9720s064001s Wskazówki dotyczące wykonywania konserwacji profili zamkniętych
- as9700z000101a Niebezpieczeństwo wybuchu i zatrucia oparami rozpuszczalników i gazami. Niebezpieczeństwo obrażeń oczu i skóry podczas obróbki środków antykorozyjnych.
- gf9800p2045a Konserwacja profili zamkniętych, informacje ogólne