Remove/install seat cushion motor for front seat

AR91.29-P-1422SCS

Remove/install seat cushion motor for front seat

6.6.07

 

Remove/install

1

Remove left or right front seat and place down with backrest on a suitable and clean shelf

AR91.10-P-1000SC

2

Remove nuts (1) and remove stowage compartment (2)

3

Remove outer front trim (3)

AR91.10-P-1200SC

4

Use heat gun to heat up bolts (4) and then remove them

 Installation: Install new bolts (4).



*BA91.10-P-1003-01O

5

Remove pin (5)

6

Remove cable tie (6)

7

Disconnect electrical connector (7)

 Release electrical connector (7) carefully, risk of breakage to electrical connector plug (7). The plug is not available as a replacement part.

8

Turn left front seat cushion fore/aft motor (M27/8) or right front seat cushion fore/aft motor (M28/8) by hand until the driver (8) is positioned at the downstop

9

Raise seat cushion with seat cushion frame (9) and route left front seat cushion fore/aft motor (M27/8) or right front seat cushion fore/aft motor (M28/8) out of the support (10) and remove

10

Install in the reverse order

11

Normalize front seat



Connect STAR DIAGNOSIS and read out fault memory

AD00.00-P-2000-04A

Number

Designation

Model 216

BA91.10-P-1003-01O

Bolt, cushion frame to seat frame

Nm

22