P88.80-2295-09
Shown on model 177 |
1 | longitudinal member panel | 3 | Expansion rivet | |
2 | Screw | 4 | Nut |
P88.80-2296-09
Shown on model 177 |
1 | longitudinal member panel | 5 | Retaining clips | |
2 | Screw | 5a | Retaining clips | |
3 | Expansion rivet | 6 | Retaining clips | |
4 | Nuts |
| Remove/install | ||
1 | Open front door. | ||
2.1 | Remove rear door. | Model 118, 177, 247.0 | |
2.2 | Mask off rear door in front bottom area with a felt strip. | Model 247.6/7 | |
Scratches to the longitudinal member paneling (1) through the rear door can be prevented by felt strips. | |||
Felt strip | |||
3 | Remove screw (2). | ||
4 | Remove expansion rivets (3) from front fender liner. | Model 247.6/7 | |
Dismantling tool | |||
5 | Remove nuts (4). | ||
6 | Lift the underfloor paneling on the side until the retaining clips (5) are accessible. | ||
7 | Unclip retaining clips (5). | Dismantling tool | |
8 | Unclip longitudinal member panel (1) along longitudinal member and remove. | Dismantling tool | |
9 | Place the longitudinal member panel (1) on a clean, soft base. | ||
| Check | ||
10 | Check old retaining clips (5, 5a, 6) for damage. | If damage is identifiable, | |
| |||
replace damaged retaining clips (5, 5a, 6). | |||
11 | Install in the reverse order. |
000 589 95 63 00
Dismantling tool