1 | Hood catch upper section |
2 | Engine hood cable |
3 | Hood catch lower section |
4 | Bolts |
5 | Engine hood |
6 | Bolts |
D88.40-1130-06
Warning | Risk of injury caused by fingers being jammed or pinched when removing, installing or aligning hoods, doors, trunk lid/rear-end door or sliding roof. | No parts of the body or limbs should be within the operating area when the components are moving. | |
| Remove | ||
1 | Mark hood catch installation position | To do this, mark the installation position of the hood catch upper section (1) and hood catch lower section (3). | |
2 | Remove hood catch upper section (1) | Remove screws (6) for this. | |
3 | Remove hood catch lower section (3) from bumper crossmember | Unscrew the screws (4) for this. | |
4 | Remove hood cable (2) from hood catch lower section (3) | | |
| Install | ||
5 | Install hood catch upper section (1) | Pay attention to installation position. | |
To do this, screw in bolts (6) loosely by hand. | |||
6 | Install hood cable (2) on hood catch lower section (3) | | |
7 | Attach hood catch lower section (3) to bumper crossmember | Pay attention to installation position. | |
To do this, screw in bolts (4) loosely by hand. | |||
| Check | ||
8 | Check engine hood lock | To do this, close hood and pull upward with a slight jerk. | |
Engine hood can be opened. | |||
| |||
Adjust hood catch. | |||
Adjust engine hood | |||
9 | Check function of safety hook on hood catch upper section (1) | Activate lever of hood cable in vehicle interior. The hood must then catch on the safety hook when opening the hood. | |
Engine hood can be opened. | |||
| |||
Adjust hood catch. | |||
Adjust engine hood | |||
10 | Check gap dimensions and height offset of the hood | ||
11 | Tighten screws (6) | Bolt, upper section of hood catch to hood | |
12 | Tighten screw/bolts (4) | Bolt, lower section of hood catch to assembly carrier |
Powiązane dokumenty
- ar8840d3020ts
- as0000z001101a Niebezpieczeństwo zranienia przez zakleszczenie lub zmiażdżenie palców podczas demontażu, montażu i prac regulacyjnych przy pokrywach, drzwiach i oknie dachowym.