Remove/install rear fender

AR88.10-P-1100SO

11.11.04

MODEL 450.300 /400 with CODE (L27) Canada

P88.10-2162-04

1 Rear fender

2 Screw

3 Shield

4 Clips

5 Rear center section

	Remove
1	Remove CBS rear	Model 450.3 /4 except Brabus 1st Edition (FFO), code P15 or complete wheel set 175-R16/225-R17 Brabus (DFO), code P18.	AR88.20-P-1900SM
		 Remove CBS rear end from body until electrical connector is disconnected on right and left.
2	Disconnect electrical connector on right and left	 Do not damage catch lugs.
3	Remove CBS rear end
4	Remove impact damper from rear fender		AR88.10-P-1105SM
5	Remove rear side marker lamp		AR82.10-P-2005SM
6	Unscrew bolt (2) from shield (3)
7	Remove clip (4)
8	Remove rear fender (1) from rear center section (5)
	Install
9	Process rear fender (1)	 Only when rear fender (1) is replaced, see:
		Drill holes for impact damper on rear fender:
		Model 450.300	AR88.10-P-1105-02SM
		Model 450.400	AR88.10-P-1105-02SN
10	Position rear fender (1) on rear center section (5)
11	Insert clips (4)
12	Screw bolts (2) into shield (3)
13	Install rear side marker lamp		AR82.10-P-2005SM
14	Install impact damper on rear fender	 Observe tightening sequence for bolts, see:	AR88.10-P-1105SM
		Tightening schematic for impact damper	AR88.10-P-1105-01SM
15	Move the CBS rear to the attachment position.
16	Connect electrical connector on right and left
17	Install CBS rear end	Model 450.3 /4 except Brabus 1st Edition (FFO), code P15 or complete wheel set 175-R16/225-R17 Brabus (DFO), code P18.	AR88.20-P-1900SM
	Check
18	Check side marker lamps for proper function