1 | Additional heat exchanger |
2 | Wood screws |
D83.60-0001-01
3 | Heating hoses |
4 | Spring-loaded band-type clamps |
D83.60-0002-11
5 | Electrical connector |
D83.60-0003-02
| Remove/install | ||
Danger ! | Risk of injury to skin and eyes suffering scalding from contact with hot coolantspray. Risk of poisoning from swallowing coolant. | Do not open cooling system unless coolant temperature is below 90 °C. Open cap slowly and release the pressure. Do not pour coolant into beverage containers. | |
| Notes on coolant | ||
1 | Lift/jack up vehicle |
| |
2 | Remove wood screws (2) | ||
3 | Disconnect electrical connector (5) | ||
4 | Clamp off heating hoses (3) | Clamp | |
5 | Loosen spring bracket clamps (4) and detach heating hoses ((3) | Collect coolant which flows out. | |
6 | Remove additional heat exchanger with connection lines and connector (5) toward top | Installation: Ensure that guides are seated correctly in vehicle floor. | |
7 | Install in the reverse order | ||
8 | Adjust coolant to correct level | ||
| Engine cooling system - check fluid level, adjust to correct level. Inspect anticorrosion/antifreeze protection, adjust to correct concentration |
000 589 40 37 00
Clamp
Powiązane dokumenty
- ah2000n208001a Wskazówki dotyczące płynu chłodzącego
- ap2000d2010h Układ chłodzenia silnika - kontrola, korekta poziomu płynu Kontrola, korekta stężenia środka zapobiegającego korozji i zamarzaniu
- ar0060d1000h Unoszenie pojazdu, podpieranie
- as2000z000101a Niebezpieczeństwo zranienia skóry i oczu przez poparzenie wytryskującym, gorącympłynem chłodzącym. Niebezpieczeństwo zatrucia na skutek połknięcia płynu chłodzącego