P83.25-2250-09
Shown without code (581) Comfort automatic air conditioning
2 Electrical connector
3 Bolts
4 Seal
5 Bolts
6 Cover
7 Electric wiring harness for A/C bus
8 Screw
M2/12 Left center air flap actuator motor
(with code (581) Comfort automatic air conditioning)
M2/22 Center outlet flap actuator motor
(without code (581) Comfort automatic air conditioning)
9 Bow
10 Clamp fixture
11 Clamps
12 Air distributor
P83.25-2251-11
Shown without code (581) Comfort automatic air conditioning
1 Heat exchanger
12 Air distributor
13 AC housing
| Remove/install | ||
1 | Remove AC housing | ||
2 | Separate self-adhesive dampening from A/C housing | ||
3 | Separate electrical connector (2) | ||
4.1 | Undo screws (3) using rechargeable battery-powered screwdriver and remove center outlet flap actuator motor (M2/22) | On vehicles without code (581) Comfort automatic air conditioning | |
Rechargeable battery-powered drill/screwdriver | |||
4.2 | Undo screws (3) using rechargeable battery-powered screwdriver and detach the left center air flap actuator motor (M2/12) | On vehicles with code (581) Comfort automatic air conditioning | |
Rechargeable battery-powered drill/screwdriver | |||
5.1 | Detach electrical connector on right center air flap actuator motor | On vehicles with code (581) Comfort automatic air conditioning | |
6.1 | Undo screws on right center air flap actuator motor using rechargeable battery-powered screwdriver and remove right center air flap actuator motor | On vehicles with code (581) Comfort automatic air conditioning | |
Rechargeable battery-powered drill/screwdriver | |||
7 | Detach seal (4) | Installation: Sealing (4) has to be replaced. | |
8 | Undo screws (5) using rechargeable battery-powered screwdriver and remove both covers (6) | Installation: Note correct routing of electrical wiring harness for the A/C bus (7) on both covers (6). | |
Rechargeable battery-powered drill/screwdriver | |||
9 | Undo screw (8) using battery-powered screwdriver | Rechargeable battery-powered drill/screwdriver | |
10 | Open bracket (9) of clamping bracket (10) in direction of arrow and remove clamping bracket (10) upwards | Installation: Note installation position of clamping bracket (10). | |
11 | Unclip brackets (11) all way round, remove air distributor (12) and place to one side | Installation: Note correct seating of air distributor (12) in evaporator housing (13). | |
12 | Remove heat exchanger (1) from evaporator housing (13) | Do not damage the sealing tape that surrounds the heat exchanger (1). | |
13 | Install in the reverse order |
Commercially available tools