ar8210s4742e

Remove/install fan for lamp unit

Typ ar · temat 82.10 · wersja 0100 · 2018-03-19

Dotyczy: Model 447, 448

Niedostępne w języku „pl”; wyświetlono w języku Angielski.

Umiejscowienie

Grupa funkcyjna 3 Nadwozie › 82 Układ elektryczny, nadwozie › 82.10 Oświetlenie zewnętrzne — Seria 447 · Seria 448

EinPAS 30 Instalacja oświetleniowa › 30.15 Oświetlenie zewnętrzne › 30.15.40 Lampa przednia — Seria 447 · Seria 448

AR82.10-S-4742E

Remove/install fan for lamp unit

01.03.2018

Model

447, 448

Remove/install fan for lamp unit

S82.10-4730-09

Shown on left lamp unit at front (1)

1

Front lamp unit

1.3

Seal

4

Fan

1.1

Housing

2

Screw

5

Bolts

1.2

Cap

3

Electrical connector

Topical note

Information on preventing damage to electronic components due to electrostatic discharge

AH54.00-P-0001-01A

Remove

1

Remove front lamp unit (1)

AR82.10-S-4730E

Caution

Risk of injury caused by burns to skin and eyes, risk of poisoning caused by inhaling vapors when working with plastics

Wear protective gloves and safety glasses. Ensure that the work area is adequately ventilated.

AS00.00-Z-0001-02A

2.1

Use hot knife to cut open housing (1.1) on front lamp unit (1) within the groove (arrow A)

If the cap (1.2) is not fitted.

000 588 03 84 00 Hot knife

WS82.00-P-0026B


Cut open the housing (1.1) so that the web (arrow B) is not damaged.
Leaks can occur otherwise.


Carefully cut open the housing (1.1).
Otherwise, component parts in the front lamp unit (1) may be damaged.

The web (arrow B) on housing (1.1) serves as the sealing surface for the cap (1.2).

2.2

Unscrew bolts (2) and remove cap (1.2)

If the cap (1.2) is fitted.

3

Deburr cut surface on front lamp unit (1)

If necessary, after cutting open housing (1.1).


Make sure there are no plastic cuttings in the front lamp unit (1).
Soiling in the front lamp unit (1) may cause malfunctions.

4

Remove screws/bolts (5)

5

Remove fan (4) far enough from front lamp unit (1) to gain access to the electrical connector (3)

6

Disconnect electrical connector (3) and remove fan (4)

Install

7

Connect electrical connector (3) to fan (4)

8

Insert fan (4) into front lamp unit (1)

The installation position of the fan (4) is defined by the hole pattern on the fan support (4).

9

Screw bolts (5) tight

10

Insert seal (1.3) with inscription facing upwards into the cap (1.2)

For first time installation of cap (1.2).

Note marking (arrow C) on cap (1.2):
"L" for left front lamp unit (1), "R" for right front lamp unit (1).

11

Position cap (1.2) on front lamp unit (1) and tighten bolts (2)

12

Install front lamp unit (1)

AR82.10-S-4730E

Powiązane dokumenty