AR80.50-P-9840TX | Remove/install ATA alarm siren | 21.11.11 |
MODEL 219.3 with CODE (551) Anti-theft alarm system (ATA [EDW])
P80.50-2508-06
1 Nuts
2 Bracket
3 Cable tie
4 Electrical connector
5 Screw
H3/1 Alarm signal horn with additional battery
| Remove/install | ||
1.1 | Switch off ignition and leave transmitter key in EIS [EZS] control unit. | On vehicles without code (889) Keyless go | |
1.2 | Switch off ignition and remove transmitter key from vehicle transmitter range | On vehicles with code (889) Keyless go | |
2 | Remove rear fender liner on left front fender | ||
3 | Turn front wheels to left | ||
4 | Unscrew nuts (1) | Replace nuts (1). | |
5 | Remove alarm siren with additional battery (H3/1) and bracket (2) until the electrical connector (4) is accessible | ||
6 | Remove cable ties (3) | Installation: Replace cable tie (3). | |
7 | Disconnect electrical connector (4) | ||
8 | Unscrew screw (5) and remove alarm signal siren with additional battery (H3/1) from mount (2) | | |
Screwdriver bit for internal Torx bolt with pin guide | |||
9 | Install in the reverse order |
Anti-theft alarm