ar8020s1922a

Removing and installing central locking control module

Typ ar · temat 80.20 · wersja 0100 · 2000-02-07

Dotyczy: MODEL 638.0 /1 as of 1.2.00 with CODE (FZ0) Central locking with key operation with CODE (FZ1) Central locking with remote control

Niedostępne w języku „pl”; wyświetlono w języku Angielski.

Umiejscowienie

Grupa funkcyjna 3 Nadwozie › 80 Zamek centralny, sterowanie komfortowe, układ uprawniający do jazdy › 80.20 Zamek centralny, wewnętrzny zamek centralny — Seria 638 (modele 0**, 1**)

EinPAS 29 System uprawniający do jazdy/zabezpieczający › 29.16 Blokowanie/ odblokowanie › 29.16.11 Moduł sterujący/ przekaźnik — Seria 638 (modele 0**, 1**)

AR80.20-S-1922A

Removing and installing central locking control module

17.11.99

MODEL 638.0 /1 as of 1.2.00
with CODE (FZ0) Central locking with key operation
with CODE (FZ1) Central locking with remote control

Removing and installing central locking control module

S80.20-4003-06

1 Right air nozzle

2 Protective bag for connectors

3 Cable strap

4 Combination plug

A4 ETC control module

A4.1 ETC control module connector

A8 Central locking control module

A8.1 Connector 1 for central locking control module

A8.2 Connector 2 for central locking control module

Removal, installation

1

Disconnect ground lead from battery

Installation: -Code radio.
-Set clock.

AR54.10-S-0005A

Notes on battery

AH54.10-P-0001-01A

2

Remove right air nozzle (1)

AR83.10-S-4740A

3

Remove paneling on right below dashboard

4.1

Remove cable strap (3) from protective bag (2)

Only with code G40 (automatic transmission).

Installation: Replace cable strap (3).

5.1

Disconnect connector (A4.1) from ETC control module (A4)

Only with code G40 (automatic transmission).

For this purpose, release locking bow on combination plug (4).

Installation: Insert combination plug (4) at rear (arrows), lock connector (A4.1) by pressing locking bow down.

6.1

Extend mount with engine control module

With code G40 (automatic transmission) do not damage electric wires.

With code G40 (automatic transmission) 2 control modules are fastened to the same mount

Connectors can remain installed on engine control module.

7

Disconnect connectors (A8.1, A8.2) from central locking control module (A8)

8

Remove central locking control module (A8) from mount

9

Pull central locking control module (A8) out of lower section of instrument panel together with associated mount

10

Remove central locking control module (A8) from mount

11

Install in opposite order

Powiązane dokumenty