ar7220d4055ts

Remove/install rear-end door lock

Typ ar · temat 72.20 · wersja 0101 · 2019-01-02

Dotyczy: Model 907.6/7, 910.6

Niedostępne w języku „pl”; wyświetlono w języku Angielski.

Umiejscowienie

Grupa funkcyjna 3 Nadwozie › 72 Drzwi › 72.20 Drzwi na ścianie tylnej, drzwi tylne — Seria 907 (modele 6**, 7**) · Seria 910 (modele 6**)

EinPAS 29 System uprawniający do jazdy/zabezpieczający › 29.16 Blokowanie/ odblokowanie › 29.16.32 Zamek/ klamka — Seria 907 (modele 6**, 7**) · Seria 910 (modele 6**)

AR72.20-D-4055TS

Remove/install rear-end door lock

14.12.2018

Model

907.6/7, 910.6

Remove/install rear-end door lock

1

Cable

2

Bearing bracket

3

Bolts

4

Door lock

5

Electrical connector

D72.20-1267-06

Remove/install rear-end door lock

4

Door lock

5

Electrical connector

6

Cables

7

Bracket

8

Cable

D72.20-1268-06

Warning

Risk of injury caused by fingers being jammed or pinched when removing, installing or aligning hoods, doors, trunk lid/rear-end door or sliding roof.

No parts of the body or limbs should be within the operating area when the components are moving.

AS00.00-Z-0011-01A

Topical note

Notes on carrying out repair work in the vehicle interior

AH68.00-N-0001-01S

Remove/install

1

Remove lower rear-end door trim.

Model 907.6/7 with code VA1 (Load compartment trim up to belt rail standard) or with code VA5 (Rear-end door full trim), model 907.6, 910.6 with code VA2 (Load compartment interior trim up to roof height (wood)) or with code VA3 (Load compartment trim up to roof height, can be washed)

Model 907.6/7
with code VA5 (Fully lined hinged rear doors)

AR72.20-D-6615TS

Model 907.6/7 with code VA1 (Load compartment trim up to belt rail standard), model 907.6, 910.6 with code VA2 (Load compartment interior trim up to roof height (wood)) or with code VA3 (Load compartment interior trim up to roof height, can be washed)

AR72.20-D-6619TS

2

Remove cable (1) from bearing bracket (2).

3

Remove screws (3) and remove door lock (4) from rear-end door until electrical connector (5) is accessible.

Screw, rotary tumbler with door lock to rear-end door

*BA72.20-N-1003-01TS

4

Disconnect electrical connector (5).

5

Mark installation position of cables (6).

6

Remove cables (6) from door lock (4).

Installation: Observe installation markings of cables (6).

7

Release catch hook (arrow A) and remove bracket (7) in direction of arrow (arrow B) from door lock (4).

8

Unhook cable (8) from door lock (4) and remove door lock (4).

9

Install in the reverse order.

Check

10

Perform function check of door lock (4).

Rear-end door

Number

Designation

Model 907.6/7, 910.6

BA72.20-N-1003-01TS

Screw, rotary tumbler with door lock to rear-end door

Nm

10

Powiązane dokumenty