Shown on model 907.7 with code D03 (Roof and rear-end doors, high version), with code V21 (Luxury interior trim) and except code W54 (Double-wing rear-end door, 270 degrees) |
1 | Hinge |
2 | Screw |
3 | Screw |
4 | Rear-end door |
D72.20-1282-76
Warning | Risk of injury caused by fingers being jammed or pinched when removing, installing or aligning hoods, doors, trunk lid/rear-end door or sliding roof. | No parts of the body or limbs should be within the operating area when the components are moving. | |
| Remove/install | ||
1 | Open relevant rear-end door (4) by approx. 180°. | ||
2 | Install lifting device on rear-end door (4). | ||
| 000 588 04 80 00 Lifting device | ||
| |||
3 | Mark installation position of relevant hinge (1) on body and rear-end door (4). | ||
4 | Remove screws (2, 3) and remove hinge (1). | Installation: Only tighten screws (2, 3) to specified torque after adjustment of relevant rear-end door (4). | |
Installation: Note markings. | |||
5 | Install in the reverse order. | ||
Adjust | |||
6 | Adjust relevant rear-end door (4). | ||
7 | Repair paintwork damage at screws (2, 3). | Use only primer filler and paints approved by Daimler AG: |
Powiązane dokumenty
- ar7220d1032ts
- as0000z001101a Niebezpieczeństwo zranienia przez zakleszczenie lub zmiażdżenie palców podczas demontażu, montażu i prac regulacyjnych przy pokrywach, drzwiach i oknie dachowym.
- ws7200p0018b