Shown on model 907.6 with code T55 (electrical actuation for right sliding door) |
3 | Rotary switch |
4 | Emergency key |
D72.16-1444-01
D72.16-1445-79
Shown on model 907.7 with code T55 (Electrical actuation for right sliding door) |
1 | Door handle | 7 | Obstruction sensor strip | |
2 | Sliding door | 8 | Plug | |
5 | Latch | 9 | Screw | |
6 | Seal |
Warning | Risk of injury caused by fingers being jammed or pinched when removing, installing or aligning hoods, doors, trunk lid/rear-end door or sliding roof. | No parts of the body or limbs should be within the operating area when the components are moving. | |
Topical note | Notes on carrying out repair work in the vehicle interior | ||
| Remove/install | ||
1 | Enter the load compartment or passenger compartment and close left and/or right sliding door (2). | ||
2 | Set rotary switch (3) on sliding door (2) to "MAN" position using the emergency key (4). | Model 907.6/7 | |
This deactivates the electric drive of the sliding door (2). | |||
3 | Release anti-entrapment strip (7) of sliding door (2) up to top third, starting from the bottom. | Model 907.6/7 | |
4 | Remove stop plug (8). | ||
5 | Pull out door handle (1) in direction of arrow (arrow A), hold in this position, and release screw (9) by approx. 5 revolutions. | WIS Service Media | |
Removal: The screw (9) on the bearing bracket is sufficiently loosened when the door handle (1) remains in the pulled position of its own accord, as shown. | |||
Installation: Press on lock (5) and tighten screw (9) on bearing bracket until a perceptible resistance can be felt on the screwdriver. If it is installed correctly, the door handle (1) jumps back to the initial position by itself. | |||
6 | Remove latch (5). | Installation: Ensure that the seal (6) is seated correctly on the sliding door (2). | |
7 | Release door handle (1) in direction of arrow (arrow B) and remove from sliding door (2) in direction of arrow (arrow C). | ||
8 | Install in the reverse order. | ||
| Check | ||
9 | Check door handle (1) for proper function. |
Powiązane dokumenty
- ah6800n000101s Wskazówki dotyczące wykonywania prac naprawczych we wnętrzu pojazdu
- ar7229d5890ts
- as0000z001101a Niebezpieczeństwo zranienia przez zakleszczenie lub zmiażdżenie palców podczas demontażu, montażu i prac regulacyjnych przy pokrywach, drzwiach i oknie dachowym.