P72.10-2721-07
1 Door lock
2 Inside door opener cable
5 Electrical connector
6 Covers
3 Inner door handle
4 Emergency release cable
P72.10-3294-04
1 Door lock
2 Inside door opener cable
7 Outside door opener cable
| Remove/install | ||
1 | Remove door paneling | ||
2 | Cut door foil in area of inner door handle (3). | Installation: Mask damage on door foil with suitable adhesive tape.Ensure that door foil is seated properly. | |
3 | Unhook inside door opener cable (2) from inner door handle (3) | Installation: Route and fasten inside door opener cable (2) to prevent damage and vibration noises. | |
Installation: The function of the power window and the inside door opener cable (2) should always be ensured by the position of the inside door opener cable (2). | |||
4.1 | Unhook emergency release cable (4) on lock cylinder from door lock (1). | Only driver side. | |
5 | Disconnect electrical connector (5) from door lock (1). | ||
6 | Remove covers (6) and unscrew bolts below | | |
7 | Pull door lock (1) out of door carcass | ||
8 | Unclip inside door opener cable (2) from door lock (1) (arrow) and unhook | Picture A. Do not damage plastic parts | |
9 | Unclip outside door opener cable (7) from door lock (1) (arrow) and unhook | Picture B. Do not damage plastic parts | |
Installation: Route and fasten outside door opener cable (7) to prevent damage and vibration noises. | |||
Installation: The function of the power window and the outside door opener cable (7) should always be ensured by the position of the outside door opener cable (7). | |||
10 | Remove door lock (1) | ||
11 | Install in the reverse order | ||
| Check | ||
12 | Check power window and door actuation mechanism for proper function |
Front door