D72.10-1141-79
Shown on model 907 on the driver's side |
1 | Front door | 3 | Electrical connectors | 5 | Bolts | ||
2 | Grommet | 4 | Door holder |
Warning | Risk of injury caused by fingers being jammed or pinched when removing, installing or aligning hoods, doors, trunk lid/rear-end door or sliding roof. | No parts of the body or limbs should be within the operating area when the components are moving. | |
Topical note | Notes on carrying out repair work in the vehicle interior | ||
| Remove | ||
1 | Open side window of left or right front door (1) completely | ||
2.1 | Switch off ignition and store transmitter key outside of transmission range (min. 2 m) | Model 907, 910 | |
2.2 | Disconnect ground line from on-board electrical system battery | Model 907, 910 with code SH1 (thorax/pelvis side airbag driver), with code SH2 (thorax/pelvis side airbag front passenger), with code SH9 (window airbag for driver and front passenger) | |
3 | Disconnect ground line of auxiliary battery |
| |
Model 907 with code E2M (auxiliary battery for retrofit consumers, engine compartment), with code SH1 (thorax/pelvis side airbag driver), with code SH2 (thorax/pelvis side airbag front passenger), with code SH9 (window airbag for driver and front passenger) | |||
4 | Disconnect ground line from auxiliary battery for park pawl emergency shift mode | Model 907 with code SH1 (thorax/pelvis side airbag driver), with code SH2 (thorax/pelvis side airbag front passenger), with code SH9 (window airbag for driver and front passenger) | |
5 | Remove grommet (2) from A-pillar | Clip remover | |
6 | Disconnect electrical connectors (3) | The number of electrical connectors (3) may vary depending on the vehicle equipment involved. | |
7 | Remove door holder (4) from A-pillar | ||
8 | Attach lifting device to front door (1) | ||
| 000 588 04 80 00 Lifting device | ||
9 | Remove screws (5) and remove front door (1) from hinges | | |
10 | Remove front door (1) from the lifting device | If required. | |
Helper required. | |||
| Install | ||
11 | Attach front door (1) to lifting device | If required. | |
| 000 588 04 80 00 Lifting device | ||
Helper required. | |||
12 | Position front door (1) on hinges and tighten screws (5) until the front door (1) is fixed to the hinges | | |
Tighten screws (5) with the specified tightening torque only after adjusting the front door (1). | |||
13 | Remove lifting device from the front door (1) | ||
14 | Attach door holder (4) to the A-pillar | ||
15 | Connect electrical connectors (3) | The number of electrical connectors (3) may vary depending on the vehicle equipment involved. | |
16 | Attach grommet (2) to the A-pillar | ||
17 | Connect ground line of auxiliary battery for park pawl emergency shift mode | Model 907 with code SH1 (thorax/pelvis side airbag driver), with code SH2 (thorax/pelvis side airbag front passenger), with code SH9 (window airbag for driver and front passenger) | |
18 | Connect ground line to auxiliary battery |
| |
Model 907 with code E2M (auxiliary battery for retrofit consumers, engine compartment), with code SH1 (thorax/pelvis side airbag driver), with code SH2 (thorax/pelvis side airbag front passenger), with code SH9 (window airbag for driver and front passenger) | |||
19 | Connect ground line to on-board electrical system battery | Model 907, 910 with code SH1 (thorax/pelvis side airbag driver), with code SH2 (thorax/pelvis side airbag front passenger), with code SH9 (window airbag for driver and front passenger) | |
20 | Adjust front door (1) | ||
| Check | ||
21 | Perform function test of all component parts installed on or in the front door (1) |
452 589 01 63 00
Clip remover
Powiązane dokumenty
- ah6800n000101s Wskazówki dotyczące wykonywania prac naprawczych we wnętrzu pojazdu
- ar5410d0004ts
- ar5410d0004tsr
- ar5410d0026tsr
- ar5410d0029ts
- ar5410d0029ts
- ar5410d0029ts
- ar7210d0550ts
- ar7210d2100ts
- as0000z001101a Niebezpieczeństwo zranienia przez zakleszczenie lub zmiażdżenie palców podczas demontażu, montażu i prac regulacyjnych przy pokrywach, drzwiach i oknie dachowym.
- ws7200p0018b