ar6830p4800r

Remove/install side paneling in trunk

Typ ar · temat 68.30 · wersja 0107 · 2008-11-05

Dotyczy: MODEL 230.4 except CODE (P99) "AMG Black Series" special model

Niedostępne w języku „pl”; wyświetlono w języku Angielski.

Umiejscowienie

Grupa funkcyjna 3 Nadwozie › 68 Wyposażenie wewnętrzne › 68.30 Wykładziny, rama ozdobna — Seria 230 (modele 4**)

EinPAS 37 Wyposażenie wnętrza › 37.45 Okładzina › 37.45.34 Okładzina bagażnika — Seria 230 (modele 4**)

AR68.30-P-4800R

Remove/install side paneling in trunk

30.10.08

MODEL 230.4 except CODE (P99) "AMG Black Series" special model

Remove/install side paneling in trunk

P68.30-3260-09

1 Left trunk paneling

2 Right trunk paneling

3 Hazard warning triangle cover

4 Hazard warning triangle

5 Left access opening cover

6 Right access opening cover

7 Electrical connector

8 Screw

14 Base

15 Left Y fixture

16 Right Y fixture

S69/10 Trunk partition "closed" limit switch

9 Trunk partition bracket

10 Screw

11 Expansion clip

12 Screw clips

13 Trunk lid seal

Remove/install side paneling in trunk

P68.30-3261-11

17 Trunk partition mount (vehicles as of 1.3.06)

Remove/install

1

Completely close Vario roof

Danger!

Risk of injury caused by moving parts that can pinch, crush or, in extreme cases, even sever extremities

No parts of the body or limbs should be within the operating range of the mechanism when moving components.

AS00.00-Z-0009-01A

2

Positioning trunk lid to assembly position

AR88.50-P-5000-01R

3

Remove trunk partition

Vehicles up to 28.2.06:

Remove/install trunk retractable partition

AR68.50-P-3000R

4

Unscrew concealed bolt (arrow) on left or right trunk partition mount (17) and remove trunk partition mount (17) toward rear.

On vehicles as of 1.3.06

5

Remove trim from rear end center assembly

AR68.30-P-4785R

6

Remove hazard warning triangle cover (3) and remove hazard warning triangle (4).

When removing left trunk paneling (1).

7

Unclip left access opening cover (5) or right access opening cover (6) and remove.

8

Disconnect electrical connector (7) from trunk partition "closed" limit switch (S69/10)

When removing right trunk paneling (2).

Access to the electrical connector (7) is accomplished via the access opening below the right access opening cover (6).

9.1

Unscrew bolt (8) and remove trunk partition bracket (9).

When removing left trunk paneling (1).

9.2

Unscrew bolt (10) and remove trunk partition "closed" limit switch (S69/10)

When removing right trunk paneling (2).

10

Remove left Y fasteners (15) or right Y fasteners (16).

11

Remove expansion clips (11) and screw clips (12).

12

Loosen left trunk paneling (1) or right trunk paneling (2) from trunk lid seal (13).

Installation: Ensure that the trunk lid seal (13) is seated correctly.

13

Pull left trunk paneling (1) or right trunk paneling (2) over support (14) and remove.

14

Install in the reverse order

Powiązane dokumenty