P68.30-3175-06
Shown on right paneling in trunk
1 Upper C-pillar paneling
2 Expanding clip
3 Edge guard
4 Rear center section paneling
5 Side trunk paneling
6 Trunk floor cover
7 Rear bench seat
8 Lower C-pillar paneling
9 Expanding clip
| Remove/Install | ||
1 | Move rear bench seat (7) to front-most position and fold over rear seat backrest | ||
2 | Open rear-end door | ||
3 | Remove edge guard (3) in area of left and right side luggage compartment lining (5) | ||
4 | Fold trunk floor cover (6) toward front | ||
5 | Remove expanding clips (2) | Installation: Replace damaged expanding clips (2). | |
| |||
6.1 | Remove expanding clips (9) | On vehicles except code (I31) Flexible luggage compartment cover | |
Installation: Replace damaged expanding clips (9). | |||
| |||
6.2 | Remove luggage compartment cover console | On vehicles with code (I31) flexible luggage compartment cover | |
7 | Loosen side luggage compartment lining (5) in area of upper C-pillar paneling (1) and lower C-pillar paneling (8) | Carefully pull side luggage compartment lining (5) out below upper C-pillar paneling (1) and lower C-pillar paneling (8) | |
Installation: Ensure that side luggage compartment lining (5) is seated correctly. | |||
8 | Fold side luggage compartment lining (5) in area of lower C-pillar paneling (8) to inside and carefully pull out below rear center section paneling (4). | ||
9 | Remove side luggage compartment lining (5) from trunk | ||
10 | Install in the reverse order |
Snap-release tool
452 589 01 63 00