1 | Side window(s) |
2 | Sealing rail |
3 | Covers |
4 | Screw |
5 | Screw |
6 | Adhesive tape |
P67.30-A012-06
P67.30-2422-08
1 | Side window(s) | 8 | Bracket |
Caution | Risk of injury from contusions to hands if window glass is not secured | Secure window to prevent it from falling down. | |
Warning | Risk of injury. Moving parts can pinch, crush or, in extreme cases even sever extremities. | No parts of the body or limbs should be within the operating area of mechanical components when moving components. | |
Warning | Risk of injury caused by fingers being jammed or pinched when removing, installing or aligning hoods, doors, trunk lid/rear-end door or sliding roof. | No parts of the body or limbs should be within the operating area when the components are moving. | |
Topical note | Information on preventing damage to electronic components due to electrostatic discharge | ||
| Remove | ||
1 | Affix tape (6), as shown, so that it is flush with the sealing rail (2) on the side window (1). | If the side window (1) is reused. | |
2 | Remove sealing rail (2). | ||
Remove door trim with connected electrical connectors. | |||
3 | Remove covers (3). | ||
4 | Raise side window (1) to topmost position so that screws (4, 5) can be accessed through access openings. | ||
5 | Switch off ignition and store transmitter key outside of transmission range (min. 2 m). | ||
6 | Release electrical connectors from the front door control unit and remove door trim. | ||
7 | Unscrew bolt (4). | ||
8 | Loosen bolt (5). | Release screw (5) until side window (1) can be removed from front door. | |
9 | Remove side window (1) from front door. | ||
10 | Unclip bracket (8) at side window (1) and remove. | When replacing side window (1). | |
| Install | ||
11 | Attach bracket (8) to side window (1). | When replacing side window (1). | |
12 | Insert side window (1) into window channel. | ||
13 | Tighten screws (4, 5) slightly by hand. | ||
14 | Install sealing rail (2). | ||
Installation: Install door trim only after the adjustment operations. | |||
15 | Push side window (1) forward until the tape (6) is flush with the sealing rail (2) as shown. | If the side window (1) is reused. | |
16 | Adjust side window (1). | ||
17 | Remove tape (6). | If the side window (1) is reused. |
Powiązane dokumenty
- ah5400p000101a Wskazówki dotyczące zapobiegania uszkodzeniom elementów elektronicznych na skutek rozładowania potencjału elektrostatycznego
- ar6730p0100mfc
- ar7210p1610mfc
- as0000z000901a Niebezpieczeństwo zakleszczenia lub zmiażdżenia, w skrajnym przypadku obcięcia kończyn podczas prac przy układach mechanicznych.
- as0000z001101a Niebezpieczeństwo zranienia przez zakleszczenie lub zmiażdżenie palców podczas demontażu, montażu i prac regulacyjnych przy pokrywach, drzwiach i oknie dachowym.
- as6700z000201a Niebezpieczeństwo obrażeń przez zmiażdżenie dłoni podczas prac przy niezabezpieczonej szybie.