1 | Side window(s) |
2 | Inner sealing rail |
3 | Outer sealing rail |
4 | Adhesive tape |
5 | Grommets |
6 | Screw |
7 | Screw |
P67.30-2416-06
P67.30-2422-08
1 | Side window(s) | 8 | Bracket |
Warning | Risk of injury caused by fingers being jammed or pinched when removing, installing or aligning hoods, doors, trunk lid/rear-end door or sliding roof. | No parts of the body or limbs should be within the operating area when the components are moving. | |
Topical note | Information on preventing damage to electronic components due to electrostatic discharge | ||
| Remove | ||
1 | Remove cover of mirror triangle in front area of outer sealing rail (3). | Long wedge | |
2 | Remove outer sealing rail (3). | ||
3 | Remove front door trim. | ||
Do not disconnect electrical connectors at front door control unit. | |||
4 | Remove grommets (5). | ||
5 | Raise side window (1) to topmost position so that screws (6, 7) can be accessed through access openings. | ||
6 | Switch off ignition and store transmitter key outside of transmission range (min. 2 m). | ||
7 | Disconnect electrical connectors at front door control unit and move door trim out of working area. | ||
8 | Affix tape (4), as shown, so that flush with inner sealing rail (2) on side window (1). | ||
9 | Release inner sealing rail (2) up to mirror triangle. | | |
Long wedge | |||
10 | Unscrew screw/bolt (6). | ||
11 | Release screw (7). | Release screw (7) until side window (1) can be removed from front door. | |
12 | Remove side window (1) from front door. | ||
13 | Unclip bracket (8) at side window (1) and remove. | When replacing side window (1). | |
| Install | ||
14 | Attach bracket (8) to side window (1). | When replacing side window (1). | |
15 | Insert side window (1) into window channel. | ||
16 | Screw in screws (6, 7) up to end stop. | ||
17 | Wet rubber seal of inner sealing rail (2) with lubricant. | Lubricant, rubber assembly 1 l | |
18 | Install inner sealing rail (2). | ||
19 | Slide side window (1) forwards until tape (4) is, as shown, flush with inner sealing rail (2). | ||
20 | Adjust side window (1). | ||
21 | Remove tape (4). | ||
22 | Install grommets (5). | ||
23 | Install outer sealing rail (3). | ||
24 | Install cover of mirror triangle. | ||
25 | Lower side window (1). | ||
26 | Install front door trim. |
115 589 03 59 00
Long wedge
Powiązane dokumenty
- ah5400p000101a Wskazówki dotyczące zapobiegania uszkodzeniom elementów elektronicznych na skutek rozładowania potencjału elektrostatycznego
- ar6730p0100fr
- ar7210p6575fr
- as0000z001101a Niebezpieczeństwo zranienia przez zakleszczenie lub zmiażdżenie palców podczas demontażu, montażu i prac regulacyjnych przy pokrywach, drzwiach i oknie dachowym.