Remove/install front door panel

AR72.10-P-6575FR

Remove/install front door panel

22.05.2018

Model

257, 290

Shown on model 257 on front door removed from left side of vehicle

1

Door trim

2

Screw

3

Cap

4

Door handle

6

Door pocket

7

Release knob

 Warning

Risk of injury caused by fingers being jammed or pinched when removing, installing or aligning hoods, doors, trunk lid/rear-end door or sliding roof.

No parts of the body or limbs should be within the operating area when the components are moving.

AS00.00-Z-0011-01A

Topical note

Information on preventing damage to electronic components due to electrostatic discharge

AH54.00-P-0001-01A

 

Remove/install

1

Completely open front door.

2

Completely open side window.

3

Switch off ignition and store transmitter key outside of transmission range (min. 2  m).

4

Remove screw/bolt (2).

5

Remove cover (3) and remove screw located underneath.

 Long wedge

*115589035900

6

Grasp door stowage compartment (6) in outermost area at front and rear (arrows a) and detach door trim (1) via a sudden pull from front door.


Detach door trim (1) by hand.
Door trim (1) can be damaged if a tool is used.

 Ensure that the front door is held in open position when pulling.
Helper required.

7

Unclip remaining retaining clips of door trim (1) up to internal sealing rail (arrow A).

8

Carefully remove door trim (1) from internal sealing rail (arrow B) starting from front up to release knob (7).

9

Detach door trim (1) (arrow D) and carefully remove from front door in the area of door lock (arrow C).

10

Remove door trim (1) from front door until electrical connectors and wire of door handle (4) can be accessed.

11

Detach wire of door handle (4) from mount.

12

Release electrical connectors from front door control unit and disconnect.

13

Release and disconnect electrical connector on speaker.

14

Remove door trim (1).

15

Install in the reverse order.