ar6430d573203ts

Install outer corner pillar paneling upper section and weld in.

Typ ar · temat 64.30 · wersja 0100 · 2018-03-26

Dotyczy: Model 907.6/7, 910.6

Niedostępne w języku „pl”; wyświetlono w języku Angielski.

Umiejscowienie

Grupa funkcyjna 3 Nadwozie › 64 Ściana tylna i tył pojazdu › 64.30 Poszycie naroża — Seria 907 (modele 6**, 7**) · Seria 910 (modele 6**)

EinPAS 35 Karoseria/ rama/ elementy domontowane › 35.31 Ściana tylna/ tył pojazdu › 35.31.30 Ściana tylna/ tył pojazdu — Seria 907 (modele 6**, 7**) · Seria 910 (modele 6**)

EinPAS 35 Karoseria/ rama/ elementy domontowane › 35.34 Ściana boczna › 35.34.45 Słupek — Seria 907 (modele 6**, 7**) · Seria 910 (modele 6**)

AR64.30-D-5732-03TS

Install outer corner pillar paneling upper section and weld in.

Danger

The high voltage used for electric welding presents a lethal hazard. Risk of explosion from welding in areas close to highly inflammable materials. Risk of injury from weld splatter and UV-light when welding. Risk of poisoning from inhaling welding gases

Use insulating mats. Wear protective clothing, safety glasses and a protective mask. Remove highly inflammable materials from the hazard area. Use air extraction system.

AS00.00-Z-0007-01A

Caution

Risk of injury caused by scraping or cutting body parts on sharp vehicle parts

Always wear protective gloves when working on or near sharp and non-deburred vehicle parts.
Deburr repair panels.

AS00.00-Z-0017-01A

Topical note

Measures for preventing damage to vehicles or components when performing electric welding work

AH00.00-N-0005-01A

000 588 02 84 00 Welder

WS60.00-P-0022K

Model

907.6/7, 910.6

The following operation steps are shown on model 907.633 with code D03 (Roof and rear-end doors, high version) on the right side of vehicle and must be performed analogously on the left side of vehicle if damaged.

Install outer corner pillar paneling upper section and weld in.

D64.30-1233-09

1

Install, align and fix upper section of outer corner pillar paneling (1) in place.

Commercially available devices/tools
Clamping pliers (Standard)

2

Outer corner pillar paneling upper section (1) (areas A and C).

Inert gas weld in intervals and allow to cool down in between.
Reduces heat distortion.

3

Tack weld outer corner pillar paneling upper section (1) (area B).

Inert gas weld in intervals and allow to cool down in between.
Reduces heat distortion.

4

Outer corner pillar paneling upper section (1) (areas D, E and F).

Inert gas weld in intervals and allow to cool down in between.
Reduces heat distortion.

5

Surface-grind inert gas spot welds, inert-gas tack welds and inert gas welds (areas A, B, C, D, E and F).

Commercially available devices/tools
Angular grinder

6

Clean weld joints.

Commercially available devices/tools
Rotary wire brush

7

Remove shavings.

Commercially available devices/tools
Wet and dry vacuum cleaner

Powiązane dokumenty