ar6430d570508ts

Install corner pillar paneling outer bottom section

Typ ar · temat 64.30 · wersja 0100 · 2017-12-14

Dotyczy: Model 907.6/7, 910.6

Niedostępne w języku „pl”; wyświetlono w języku Angielski.

Umiejscowienie

Grupa funkcyjna 3 Nadwozie › 64 Ściana tylna i tył pojazdu › 64.30 Poszycie naroża — Seria 907 (modele 6**, 7**) · Seria 910 (modele 6**)

EinPAS 35 Karoseria/ rama/ elementy domontowane › 35.31 Ściana tylna/ tył pojazdu › 35.31.30 Ściana tylna/ tył pojazdu — Seria 907 (modele 6**, 7**) · Seria 910 (modele 6**)

EinPAS 35 Karoseria/ rama/ elementy domontowane › 35.34 Ściana boczna › 35.34.45 Słupek — Seria 907 (modele 6**, 7**) · Seria 910 (modele 6**)

AR64.30-D-5705-08TS

Install corner pillar paneling outer bottom section

Danger

The high voltage used for electric welding presents a lethal hazard. Risk of explosion from welding in areas close to highly inflammable materials. Risk of injury from weld splatter and UV-light when welding. Risk of poisoning from inhaling welding gases

Use insulating mats. Wear protective clothing, safety glasses and a protective mask. Remove highly inflammable materials from the hazard area. Use air extraction system.

AS00.00-Z-0007-01A

Caution

Risk of injury caused by scraping or cutting body parts on sharp vehicle parts

Always wear protective gloves when working on or near sharp and non-deburred vehicle parts.
Deburr repair panels.

AS00.00-Z-0017-01A

Topical note

Measures for preventing damage to vehicles or components when performing electric welding work

AH00.00-N-0005-01A

000 588 01 84 00 Welder

WS60.00-P-0021K

000 588 02 84 00 Welder

WS60.00-P-0022K

Model

907.6/7, 910.6

The following operation steps are shown on model 907 for the right side of the vehicle and must be similarly performed on the left side of the vehicle in the event of damage.

Install corner pillar paneling outer bottom section

1

Install, fit and fix in place corner pillar paneling lower section (1).


Align corner pillar paneling lower section (1) with hole (arrow).



2

Corner pillar paneling lower section (1) (area P).



3

Corner pillar paneling lower section (1) (areas R, R1, P1, Q and O).



4

Corner pillar paneling lower section (1) (area N).


D64.30-1223-06

Install corner pillar paneling outer bottom section

5

Corner pillar paneling lower section (1) (area T).



6

Corner pillar paneling lower section (1)   (areas S, O1).



7

Corner pillar paneling lower section (1) (area T1).



8

Clean weld joints.



9

Remove shavings.


D64.30-1222-06

Powiązane dokumenty