ar6430d085103ts
Prepare mounting support for rear-end door hinge for installation
Typ ar · temat 64.30 · wersja 0100 · 2017-11-02
Dotyczy: Model 907.6/7, 910.6
Niedostępne w języku „pl”; wyświetlono w języku Angielski.
Umiejscowienie
Grupa funkcyjna 3 Nadwozie › 64 Ściana tylna i tył pojazdu › 64.30 Poszycie naroża — Seria 907 (modele 6**, 7**) · Seria 910 (modele 6**)
EinPAS 35 Karoseria/ rama/ elementy domontowane › 35.31 Ściana tylna/ tył pojazdu › 35.31.30 Ściana tylna/ tył pojazdu — Seria 907 (modele 6**, 7**) · Seria 910 (modele 6**)
AR64.30-D-0851-03TS
| Prepare mounting support for rear-end door hinge for installation
|
|
|
Caution
| Risk of injury caused by scraping or cutting body parts on sharp vehicle parts
| Always wear protective gloves when working on or near sharp and non-deburred vehicle parts.
Deburr repair panels.
| AS00.00-Z-0017-01A
|
The following operation steps are shown on the right component part and must be accomplished analogously on the left side in the event of damage.
1
| Punch 6 mm dia. holes in the mounting support (1) (areas A, B, and C).
|
2
| Grind cross-hatched areas on mounting support (1) down to bare metal around the holes.
|
Powiązane dokumenty
- as0000z001701a Niebezpieczeństwo obrażeńo elementy pojazdu o ostrych krawędziach.
