129 589 03 21 00
Feeler gauge
Repair materials |
Number | Designation | Order number |
BR00.45-Z-1043-13A | Blind rivet with countersunk head 6.414.0 (clamping range 1.5 mm to 3 mm, draw-off strength min. 15.5 kN) | A 000 991 82 32 |
BR00.45-Z-1056-07A | 1K-zinc dust paint | A 000 986 28 00 |
BR00.45-Z-1162-02A | Parts kit for 2-component adhesive for body | A 012 989 17 71 |
P64.20-6782-09
Shown on model 177.0 |
1 | Install rear-end center section (1) and fit. |
2 | Install trunk lid seal. |
3 | Install striker eye. |
4 | Check gaps using feeler gauge and adjust.Model 177.0 |
5 | Fix rear-end center section (1) in place. |
6 | Remove trunk lid seal. |
7 | Remove striker eye. |
8 | Drill rivet holes in the rear-end center section (1) with a diameter of 6.7 mm through the existing holes in the body and countersink (area A1, A2, A3, and A4). |
9 | Remove rear-end center section (1). |
10 | Deburr rivet holes on rear-end center section (1) and body on both sides. |
11 | Remove drilling chips. |
12 | Coat insides of the riveted joints that are not bonded with zinc dust paint. |
P64.20-6783-08
Shown on model 177.0 |
13 | Apply 2-component adhesive to the body in the cross-hatched area. |
Observe pretreatment of bonding surfaces and manufacturer's specifications for drying and processing time of 2-component adhesive. |
P64.20-6784-09
Shown on model 177.0 |
14 | Install rear-end center section (1) and fix in place. |
15 | Rivet rear-end center section (1) with a countersunk-head blind rivet with a diameter of 6.4 x 14.0 mm (area C1, C2, C3 and C4). |
P64.20-A263-09
Shown on model 177.0 |
16 | Rear-end center section (1) (area D1, D2, D3, D4, D5, D6, D7, and D8). |