P63.50-2836-06
The following operation steps are shown on model 171.
1 Install rear fender, trunk lid, taillamps, rubber seal and lock striker and fit.
2 Check gaps and adjust
3 Fix rear fender in place.
4 Remove trunk lid, taillamps, rubber seal and lock striker.
P63.50-3757-04
5 Drill Ø 6.7 mm rivet holes on rear fender (1) (areas E and H).
6 Remove rear fender (1)
7 Deburr rivet holes on both sides
8 Coat insides of riveted joints with zinc dust paint.
9 Apply 2-component adhesive in cross-hatched area.
Observe pretreatment of bonding surfaces. Refer to the manufacturer's information for the curing and working times of 2-component adhesive.
P63.50-2842-03
P63.50-2847-06
10 Install rear fender (1) and fix in place.
11 Adapt wheel arch on rear fender (1) and connect (area N).
P63.50-3754-06
12 Rivet rear fender (1) with Ø 6.5 12.5 mm with blind rivet (area H).
13 Rear fender (1) MIG solder area (A1).
14 Weld in rear fender (1) with (areas A, B, G and I).
P63.50-3756-09
15 Rivet rear fender (1) with Ø 6.5 12.5 mm with blind rivet (area E).
16 Rear fender (1) (areas A, F, K , L and M1).
Area (M1) only present on model 172.
17 Weld in rear fender (1) with (area M).
Only perform on model 171.