ar6330d000403ts

Weld in outer sliding door entry

Typ ar · temat 63.30 · wersja 0100 · 2018-02-13

Dotyczy: Model 907.6/7, 910.6 with code T16 (Sliding door right) Right side of vehicle Model 907.6/7, 910.6 with code T19 (Sliding door left) Left side of vehicle

Niedostępne w języku „pl”; wyświetlono w języku Angielski.

Umiejscowienie

Grupa funkcyjna 3 Nadwozie › 63 Ściana boczna › 63.30 Podłużnica na zewnątrz — Seria 907 (modele 6**, 7**) · Seria 910 (modele 6**)

EinPAS 35 Karoseria/ rama/ elementy domontowane › 35.20 Kabina kierowcy/ karoseria › 35.20.50 Wejście — Seria 907 (modele 6**, 7**) · Seria 910 (modele 6**)

AR63.30-D-0004-03TS

Weld in outer sliding door entry

Danger

The high voltage used for electric welding presents a lethal hazard. Risk of explosion from welding in areas close to highly inflammable materials. Risk of injury from weld splatter and UV-light when welding. Risk of poisoning from inhaling welding gases

Use insulating mats. Wear protective clothing, safety glasses and a protective mask. Remove highly inflammable materials from the hazard area. Use air extraction system.

AS00.00-Z-0007-01A

Caution

Risk of injury caused by scraping or cutting body parts on sharp vehicle parts

Always wear protective gloves when working on or near sharp and non-deburred vehicle parts.
Deburr repair panels.

AS00.00-Z-0017-01A

Topical note

Measures for preventing damage to vehicles or components when performing electric welding work

AH00.00-N-0005-01A

000 588 01 84 00 Welder

WS60.00-P-0021K

000 588 02 84 00 Welder

WS60.00-P-0022K

Model

907.6/7, 910.6

with code T16 (Sliding door right)

Right side of vehicle

Model

907.6/7, 910.6

with code T19 (Sliding door left)

Left side of vehicle

The next steps are shown on model 910.631 with code D03 (roof and rear-end doors, high version) and code T16 (right sliding door) on the right side of the vehicle and must be carried out in the same way for vehicles with code T19 (left sliding door) on the left side of the vehicle in the event of damage.

Weld in outer sliding door entry

1

Install outer sliding door entrance (1), fit and fix in place.



2

Outer sliding door entrance (1) (areas B and C).



3

Outer sliding door entrance (1) (area D).



4

Outer sliding door entry (1) (area A).



5

Clean all weld joints.



6

Surface-grind inert gas welds and inert gas plug welds on outer sliding door entrance (1) (areas A and D).



7

Remove shavings.



8

Restore surface on outer sliding door entrance (1) and smooth (area A).


Various methods can be applied to restore the surface.


D63.30-0342-06

Powiązane dokumenty