MODEL | 415.605 |
without CODE T19 (Sliding door left) |
S63.10-5173-09
1 | Mark separating point on side wall paneling (1) and cut (area A). |
Transfer separation point from vehicle. |
S63.10-5174-09
2 | Punch holes for MAG welding on main floor (1) (areas B, C). |
3 | Grind down mating surfaces to bare metal on sidewall paneling (1) in crosshatched areas and around the holes (areas B and C). |
Sand down spot weld flanges to bare metal on both sides. |
4 | Remove shavings and drill chips. |
5 | Coat insides of spot weld flanges with zinc dust paint. |
Do not coat bonding surface (area D) with zinc dust paint. |
Observe preliminary treatment of bonding surface. |
S63.10-5175-09
6 | Grind mating surfaces down to bare metal on sidewall paneling (1) in crosshatched areas. |
Sand down spot weld flanges to bare metal on both sides. |
7 | Remove shavings and drill chips. |
8 | Coat insides of spot weld flanges with zinc dust paint. |
S63.10-5176-09
9 | Punch holes for MAG welding on side wall paneling (1) (area E). |
10 | Grind down mating surfaces to bare metal on sidewall paneling (1) in crosshatched areas and around the holes (areas E). |
Sand down spot weld flanges to bare metal on both sides. |
11 | Remove shavings and drill chips. |
12 | Coat insides of spot weld flanges with zinc dust paint. |