P63.10-4204-08
For all operation steps, observe information on pretreatment of bonding surfaces.
1 Grind mating surfaces on outer C-pillar (2) and strut (5) down to bare metal using round wire brush on both sides (areas A, B, C, D, E, H and J).
2 Grind mating surface on outer C-pillar (2) down to bare metal using round wire brush on one side (area A1).
3 Coat insides of spot weld flanges with zinc dust paint (areas E, H and J).
P63.10-4205-06
4 Grind mating surfaces on inner C-pillar (1) down to bare metal using round wire on one side from inside (areas K2, K3, K4, K5 and K6).
5 Grind mating surfaces on inner C-pillar (1) down to bare metal using round wire brush on one side (areas K1, K7, K8, K9, K10, L1, L2 and L3).
6 Coat insides of spot weld flange with zinc dust paint (areas L1, L2 and L3).
P63.10-4220-12
7 Scribe position of cut (M) on outer rear wheel well (3), cut using body saw and remove section.
Cut (M) directly in rabbet to allow overlapping spot welding during assembly.
8 Grind mating surfaces on outer rear wheel well (3) down to bare metal using round wire brush on both sides (areas N, P, Q, S, T and W).
9 Grind mating surfaces on outer rear wheel well (3) down to bare metal using round wire brush on one side (areas U and V).
10 Coat insides of spot weld flange with zinc dust paint (areas N, P and Q).