MODEL | 909.843 |
with CODE W03 (Body extension) |
The following operation steps are shown on the left side of the vehicle on model 909.843 and must be performed analogously on the right side in the event of damage.
1 | Install duplicator (2), fit and fix in place. |
2 | Duplicator (2) (area A). |
Complete inert gas welds at intervals holding a steel or copper block from outside, allow to cool down in between. |
Make inert gas welds with a length of approx. 5 mm each at intervals of approx. 150 mm. |
3 | Grind inert gas weld down flat (area A). |
D63.10-1709-11
D63.10-1710-09
4 |
Install rear side wall (1), fit and fix in place. |
5 |
Tack weld rear side wall (1). |
6 |
Rear side wall (1) (area B). |
7 |
Rear side wall (1) (areas D, F and H). |
8 |
Rear side wall (1) (areas C and J). |
Complete inert gas welds at intervals holding a steel or copper block from outside, allow to cool down in between. |
Make inert gas welds with a length of approx. 5 mm each at intervals of approx. 30 mm. |
9 |
Level inert gas welds (area J). |
Inert gas welds are sealed later with sealant. |
10 |
Grind rear side wall (1) down flat (areas C, D, F and H). |
11 |
Restore surface and smooth (areas C, D, F and H). |
12 |
Remove grinding dust. |