ar6310d002802f

Prepare rear sidewall paneling behind wheel arch up to bead for installation

Typ ar · temat 63.10 · wersja 0100 · 2013-10-02

Dotyczy: MODEL 909.843 with CODE W03 (Body extension)

Niedostępne w języku „pl”; wyświetlono w języku Angielski.

Umiejscowienie

Grupa funkcyjna 3 Nadwozie › 63 Ściana boczna › 63.10 Ściana boczna — Seria 909 (modele 843)

EinPAS 35 Karoseria/ rama/ elementy domontowane › 35.34 Ściana boczna › 35.34.35 Błotnik/ ściana boczna — Seria 909 (modele 843)

EinPAS 35 Karoseria/ rama/ elementy domontowane › 35.34 Ściana boczna › 35.34.38 Poszycie z lewej strony — Seria 909 (modele 843)

EinPAS 35 Karoseria/ rama/ elementy domontowane › 35.34 Ściana boczna › 35.34.39 Poszycie z prawej strony — Seria 909 (modele 843)

AR63.10-D-0028-02F

Prepare rear sidewall paneling behind wheel arch up to bead for installation

MODEL

909.843

with CODE W03 (Body extension)

Prepare rear sidewall paneling behind wheel arch up to bead for installation

D63.10-1707-08

The following operation steps are shown on the left side of the vehicle on MODEL 909.843 and must be performed analogously on the right side in the event of damage.

1

Scribe cut on rear side wall (1) and cut (area A).

Dimensions:
a = 35 mm

2

Grind rear side wall (1) down to bare metal on outside in cross-hatched areas.

Sand down spot weld flanges to bare metal on both sides.

3

Coat inside of spot welding flanges with zinc dust paint.

Prepare rear sidewall paneling behind wheel arch up to bead for installation

4

Drill holes for plug welding on rear side wall (1) (areas B).


Transfer position of holes for body.


5

Remove grinding dust and drill chips.

D63.10-1711-11

Prepare rear sidewall paneling behind wheel arch up to bead for installation

6

Fabricate duplicator (2) of approx. 1.5 mm thick sheet steel.


Dimensions:
b = 400 mm
c = 60 mm


7

Grind duplicator (2) down to bare metal in crosshatched area.


8

Remove grinding dust.

D63.10-1708-03