Refer to the superordinate service document for further information.
Observe safety information in the superordinate service document.
The next steps are shown on model 447 with code T19 (left sliding door) on the left side of the vehicle and must be carried out in the same way on the right side of the vehicle in the event of damage.
S61.10-A032-08
Shown on model 447.813 with engine 651 |
S61.10-A019-08
Shown on model 447.813 with engine 780.702 |
1 | Mark separating point on center floor (1) (area A). |
Transfer separation point from vehicle. |
2 | Cut separating point at center floor (1) (area A). |
3 | Drill holes in center floor section (2) with Ø 7 mm (areas B1 and B2). |
4 | Model 447.7/813/815 with engine 780.702 |
5 | Grind mating surfaces at center floor section (2) down to bare metal in cross-hatched areas and around holes (areas B1, B2, B3, B4 and B5). |
Sand down spot weld flanges to bare metal on both sides. |
6 | Remove shavings and drill chips. |
7 | Install, fit and fix in place center longitudinal frame member (3). |
8 | Model 447.7/813/815 with engine 780.702 |
9 | Mark outer contours of front longitudinal frame member (6) at contact areas at center longitudinal frame member (3) (arrow D). |
Mark contours of contact areas at center longitudinal frame member (3) at both sides (arrow D). |
10 | Remove center longitudinal frame member (3). |
S61.10-A020-06
S61.10-A021-09
11 | Drill holes in center longitudinal frame member (3) with Ø 7 mm (areas E, F and G). |
12 | Grind mating surfaces at center longitudinal frame member (3) down to bare metal in cross-hatched areas and around holes (areas E, F and G). |
Sand down spot weld flanges to bare metal on both sides. |
13 | Remove shavings and drill chips. |